Whirlpool CLHB 12 NB Mode d'emploi télécharger pdf (Page 6)

GB4

REPLACING THE INJECTORS (see the injector table in the Instruction)

ADJUSTING MINIMUM GAS SETTING OF TAPS

REFERENCE TO LOCAL REGULATIONS

Provision for ventilation

The room in which the appliance is installed must have an air supply to current B.S. 5440 - Part 2 standards.

All rooms require a permanent vent in addition to the openable window.

If there are other fuel burning appliances in the same room B.S. 5440 - Part 2 should be consulted to determine the air vent

requirements.

If the appliance is installed in a cellar or basement, it is advisable to provide an air vent of 65 cm, irrespective of the room

volume.

Gas Safety Regulations

The law requires that all gas appliances are installed by competent persons in accordance with the current gas safety

regulations. Failure to install appliances correctly may lead to prosecution.

It is in your own interest, and that of safety, to ensure that the law is complied with. The hob should be installed in

accordance with the Gas Safety (Installation and Use) Regulations, the Building Regulations issued by the Department

of the Environment and the Building Standard (Scotland) (Consolidation) Regulations, issued by the Scottish

Development Department.

In the G.B., CORGI registered installers work to safe standards of practice.

•Remove grids (A).

•Extract burners (B).

• Using a socket spanner of the appropriate size

unscrew the injector (C), unscrew the injector to be

replaced.

• Replace it with the injector suitable for the new

type of gas.

• Re-assemble the injector in (D).

• If you have a multiple crown burner use side

spanner to replace the injector (E).

Before installing the hob, remember to affix the gas

calibration plate supplied with the injectors in such a way

that it covers the existing information relating to gas

calibration.

To ensure that the minimum setting is correctly adjusted, remove the knob and

proceed as follows:

• tighten screw to reduce the flame height (-);

• loosen screw to increase the flame height (+).

The adjustment must be performed with the tap in minimum gas setting position

(small flame) .

• The primary air of the burners does not need to be adjusted.

• At this stage, light up the burners and turn the knobs from max position to

minimum position to check flame stability.

Upon completion of adjustment, reseal using sealing wax or an equivalent material.

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Whirlpool CLHB 12 NB Mode d'emploi Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Whirlpool CLHB 12 NB