Whirlpool ACM 804 LX Mode d'emploi télécharger pdf (Page 8)

EN16

Connect the yellow/green earth wire to the terminal with the symbol .

This wire must be longer than the other wires.

1. Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block hinge (B).

2. Insert the power cable in the cable clamp and connect the wires to the terminal block as indicated in the connection diagram located near it.

3. Secure the power cable with the cable clamp.

4. Close the cover (C) and screw it on the terminal block with the previously removed screw.

Each time the power is connected, the hob performs an automatic check for a few seconds.

If the hob already has a power cable, follow the instructions attached to the cable. Connect the appliance to the power supply by means of a multipole switch with

minimum contact gap of 3mm.

Control Panel Description

Control panel

Switching the hob ON/OFF

To switch the hob on, press the button for approx. 2 seconds until the cooking zone displays light up. To switch off, press the same button until the displays switch

off. All the cooking zones are deactivated

If the hob has been in use, the residual heat indicator “H” remains lit until the cooking zones have cooled down.

If within 10 seconds of switching on, no function is selected, the hob switches off automatically.

Switching on and adjusting cooking zones

INSTRUCTIONS FOR USE

Control panel lock

Cooking zone controls and corresponding display

On/Off

“Flexicook model” (when available)

Quick access

Slider

Cooking zone controls and corresponding display