Whirlpool KHMF 9010/I Mode d'emploi télécharger pdf (Page 11)

Technical information for the installer

• This product can be built into a 20 to 40 mm deep worktop.

• The hob cannot be installed with an oven underneath. Always insert a separator panel under

the hob at a distance of no less than 25 mm from the lowest point (electronic control

module) on the appliance. Follow the measures shown in the “Sizes and installation

measurements (mm)” section.

Before installation, make sure that:

• Warning: this is a heavy products which requires the installation to be carried out by two

people.

• The local gas mains (type and pressure) and the calibration on the hob are compatible (see

serial no. plaque and injector table).

• The covering on the walls of the appliance or appliances next to the hob are heat resistant in

compliance with local regulations.

• The combustion smoke is released via proper suction hoods or electrical fans installed on the

walls and/or windows.

• The air circulates naturally through a suitable opening that is no less than 100 cm

practicable section, which must be:

• Permanent and accessible on the walls of the room being ventilated and extracting towards

the outside

• Created in such a way that the openings, both inside and out, cannot be obstructed, not

even by mistake

• Protected by plastic grills, metallic netting etc. that, under no condition, should reduce the

practicable section indicated above

• Located close to the floor and placed in such a way that it does not interfere with the

extraction of the combustion smoke.

Installation

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

Whirlpool KHMF 9010/I Mode d'emploi Page 11