Whirlpool HOB 461 S Mode d'emploi télécharger pdf (Page 34)

Adjusting the gas burner minimum

For taps with adjusting screw inside the shaft:

• with a screwdriver, max. diameter 3 mm, turn

the screw inside the tap shaft until

adjustment is correct;

• perform the adjustment with the tap in the

minimum position (small flame).

For taps with adjusting screw on the body:

• with a screwdriver turn screw “A” until

adjustment is correct;

• in the models with ignition incorporated in the

knob access to screw “A” is through a hole in

the microswitch;

• perform the adjustment with the tap in the

minimum position (small flame).

For gas G30/G31 tighten the adjusting screw

completely.

Correct adjustment of the flame

Make sure that the appearance of the flame is

well defined, stable and even. Also make sure

that when turning from the max opening position

to the min opening position the flame does not go

out.

GAS TAP LUBRICATION

If a gas tap is difficult to turn, disassemble it,

clean it carefully with petrol and spread a little

special high-temperature resistant grease on it.

These operations should be performed by a

specialised engineer.

INSTALLATION INSTRUCTIONS

82569_GB.fm Page 91 Wednesday, March 21, 2001 5:18 PM

Black process 45,0° 133,0 LPI

1 2 ... 29 30 31 32 33 34 35 36

Pas de commentaire

Whirlpool HOB 461 S Mode d'emploi Page 34