15
DECLARATION OF CONFORMITY
- This appliance has been designed, manufactured and marketed in conformity with the safety requirements of “Low Voltage” Directive 2006/95/EC (replacing
73/23/EEC as amended) and protection requirements of “EMC” Directive 2004/108/EC.
- This appliance meets the eco design requirements of European Regulation N. 66/2014, in conformity to the European standard EN 60350-2.
BEFORE USE
IMPORTANT: The cooking zones will not switch on if pots are not the right size. Only use pots bearing the symbol “INDUCTION SYSTEM”
(Figure opposite). Place the pot on the required cooking zone before switching the hob on.
EXISTING POTS AND PANS
NO
OK
Use a magnet to check if the pot is suitable for the induction hob: pots and pans are unsuitable if not magnetically detectable.
- Make sure pots have a smooth bottom, otherwise they could scratch the hob. Check dishes.
- Never place hot pots or pans on the surface of the hob’s control panel. This could result in damage.
RECOMMENDED POT BOTTOM WIDTHS
Ø
28 cm
XL
Ø
17 cm min. 28 cm max.
Ø
21 cm
L
Ø
15 cm min. 21 cm max.
Ø
18 cm
M
Ø
14,5 cm
S
Ø
12 cm min. 18 cm max.
Ø
10 cm min. 14,5 cm max.
Ø
12 cm
Flexicook
39 cm
23 cm
Max. Min.
INSTALLATION
After unpacking the product, check for any damage during transport. In case of problems, contact the dealer or the After-Sales Service. For built-in dimensions
and installation instruction, see the pictures in page 2.
PREPARING THE CABINET FOR FITTING.
- Install a separator panel under
the hob.
- The lower part of the product must
not be accessible after installation.
- Do not t the separator panel if
an undertop oven is installed.
• The distance between the underside of the appliance and the separator panel must respect the dimensions given in the gure.
• In order to ensure the correct operation of the product, do not obstruct the minimum required clearance between the hob and the top of the unit (min. 5 mm).
• If an undertop oven is installed, make sure the oven is equipped with a cooling system.
• Do not install the hob above a dishwasher or washing-machine, so that the electronic circuits do not come into contact with steam or moisture which could
damage them.
• In the case of ush-mounted installation, call the After-Sales Service to request assembly of screws kit 4801 211 00112.
• To remove the hob, use a screwdriver (not provided) to prise off the perimeter clips on the underside of the appliance.
ELECTRICAL CONNECTION
- Disconnect the appliance from the power supply.
- Installation must be carried out by qualied personnel who know the current safety and installation regulations.
- The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the regulations
provided in this chapter.
- The power cable must be long enough to allow the hob to be removed from the worktop.
- Make sure the voltage specied on the dataplate located on the bottom of the appliance is the same as that of the home.
6-7 cm
Min. 20 mm
(44 pages)
(36 pages)
(48 pages)
(7 pages)
(52 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels