Whirlpool WWDC 9716 Guide d'utilisation et d'entretien télécharger pdf (Page 26)

WARNING

Make sure that the washer dryer has been shut

o and disconnected from its electrical power

supply before cleaning the water lter or draining

the residual water.If a high temperature wash

programme has recently been used, wait for the

water to cool before draining it.

The water lter should be cleaned regularly in

order to prevent water from remaining inside

the appliance after wash cycles due to lter

obstructions.

CLEANING THE WATER FILTER /

DRAINING THE RESIDUAL WATER

1. Remove the kick panel: Using a screwdriver,

do that which is shown in the following gure.

2. Container for the drained water:

Place a low and wide container under the water

lter in order to collect the residual water.

3. Drain the water:

Slowly turn the lter counter-clockwise until all the

water has come out.Allow the water to ow out

without removing the lter.

Once the container is full, close the water lter by

turning it clockwise. Empty the container. Repeat

the procedure until all the water has been drained.

4. Remove the lter: Place a cotton cloth under

the water lter in order to absorb any small

amounts of residual water. Next, remove the water

lter by turning it counter-clockwise.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 37 38

Pas de commentaire

Whirlpool WWDC 9716 Guide d'utilisation et d'entretien Page 26