Whirlpool WWDC 9716 Mode d'emploi télécharger pdf (Page 12)

The following levels are available:

Wardrobe : laundry is completely dry and ready to be put

away in the wardrobe without ironing.

Hanger : laundry is left slightly damp to minimise

creasing. Garments must be hung to air dry completely.

Iron : garments are left reasonably damp to make ironing

easier.

- Timer drying mode:

Press button “Paramètre de séchage” repeatedly to set timer

drying mode. After cycling through all the automatic drying

levels, continue pressing button “Paramètre de séchage”

until the desired time is displayed.

Values from 210 to 30 minutes are settable.

Timer drying is not compatible with the RAFRAÎCHIR, RAPIDE

30’ and VIDANGE SEULEMENT programmes.

N.B.: always allow a cooling down period after drying before

opening the door.

5. USING THE CORRECT AMOUNT OF DETERGENT. Pull out

the tray and pour detergent into the relative compartments

as described in “Detergent dispenser”. This is only necessary

when using a wash only or a wash + dry programme.

6. DELAYING THE START OF A PROGRAMME. To set a

programme to start at a later time, see the section “Options

and Functions”.

7. STARTING A PROGRAMME.

Press the START/PAUSE button. The relative indicator lamp

illuminates, the door locks and the door open symbol

extinguishes. To change a programme while a cycle is in

progress, press START/PAUSE to pause the washer dryer (the

START/ PAUSE lamp ashes amber slowly); then select the

required cycle and press START/PAUSE again. To open the

door while a cycle is in progress, press START/PAUSE; the door

may be opened if the symbol lights. Press the START/

PAUSE button again to resume the programme from where it

was paused.

8. CANCELLING A RUNNING PROGRAMME IF NECESSARY

Press and hold the button until the washer dryer stops.

If the water level and temperature are low enough, the door

unlocks and may be opened.

The door remains locked if there is water in the drum. To

unlock the door, switch the washer dryer on, select the

ESSORAGE & VIDANGE programme and turn the spin function

o by setting the spin speed to 0. The water is emptied and

the door unlocks at the end of the programme.

9. SWITCHING THE WASHER DRYER OFF AT THE END OF A

PROGRAMME.

At the end of the cycle, the message “END” is shown on the

display. The door can only be opened when the symbol

lights. Check that the door unlocked symbol is lit, then open

the door and take out the laundry.

Press to switch the washer dryer o. To save energy, if the

washer dryer is not switched o manually with the

button, it turns o automatically approximately 30 minutes

after the end of the programme.

Leave the door ajar to let the interior of the washer dryer dry.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Whirlpool WWDC 9716 Mode d'emploi Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Machines à laver Whirlpool WWDC 9716