Whirlpool CA8WR42 Instructions d'exploitation télécharger pdf (Page 18)

3. Remove the front panel. (See “Cleaning the front

panel” on page 12.)

4. Remove the side curtains. Slide curtains out to fullest

width. From the back side, remove the Phillips-head

screws which attach the curtain to the cabinet (A).

See Figure 8.

5. Remove slotted-hex head screws (B) holding top

channel. See Figure 8.

6. Remove siotted-hex head screws (C) on sides of

cabinet. See Figure 8.

7. Remove the cabinet from the air conditioner. Watch

out for the sharp metal fins on the front and rear coils.

8. Wrap the fan motor(E), capacitor connections (F),

electrical control panel (I), and compressor terminals

(J) in plastic film and make sure no water or other

liquid gets inside any of these parts. It could damage

the insulation and cause serious mechanical problems.

See Figure 9.

9. Carefully clean and hose out the base (K), condenser

coil (D), evaporator coil (G), and condensate pan (H).

Clean at least once a year or more often if the con-

denser and evaporator coils and pan collect dirt, sand,

leaves, insects, or algae. Also, clean if you detect an

odor coming from the air conditioner. See Figure 9.

10. Remove the plastic film from the motor and

electrical parts.

11. Replace the cabinet on the air conditioner and reattach

the front panel, top channel, and side curtains.

12. Plug in the power cord.

NOTE: It is a good idea to wait 24 hours before starting

the air conditioner again. This allows time for all areas

to dry out.

Repairing paint damage

Check once or twice a year for paint damage. This may

occur, especially in salty environments (near oceans, etc.)

or where rust is a problem. If needed, touch up with a good

grade enamel paint.

NOTE: To reduce paint damage during the winter, install

a heavy-duty cover on your air conditioner’s cabinet. For

information on ordering a heavy-duty cover see page 26.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 37 38

Pas de commentaire

Whirlpool CA8WR42 Instructions d'exploitation Page 18