Whirlpool CA8WR42 Instructions d'exploitation télécharger pdf (Page 12)

Normal operating sounds

When your air conditioner is operating normally, you may

hear such sounds as:

l A “pinging” sound caused from water droplets hitting the

condenser. This is an energy efficient design whereby

the water cools the condenser.

l Air movement from the fan.

l Clicks from the thermostat cycling on and off.

l Vibrations or noise due to poor wall or window

construction.

l A high pitched hum or pulsating noise caused by the

modern high efficiency compressor cycling on and off.

Cleaning

Instructions

It is necessary to clean your air filter and front panel

properly for top performance and cleaner air.

Cleaning the front panel

1. Unplug the power cord.

2. Remove the front panel from the cabinet for easy

cleaning. Press down on the top of the front panel and

tilt forward. Lift the front panel up and away from the

bottom spring clips. See Figure 6.

3. Remove the air filter and clean it separately if needed.

(See “Cleaning the air filter” on page 14.)

4. Using a soft cloth, clean the front panel with warm water

and a mild soap or detergent. Rinse and dry thoroughly.

Wipe the control panel with a soft, dry cloth.

5. Replace the front panel. Set the bottom of the panel on

the cabinet spring clips. Push down and forward into the

cabinet to secure upper tabs.

6. Plug in the power cord.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 37 38

Pas de commentaire

Whirlpool CA8WR42 Instructions d'exploitation Page 12