Whirlpool GBS307 Manuel de service télécharger pdf (Page 15)

2-3

Personal Injury Hazard

• Use both hands to remove oven doors.

• Do not use the handle or any portion of the

front frame or trim for lifting.

• Because of the weight and size of the

oven, two or more people are required to

move and safely install it.

Failure to properly grasp the oven doors or to

lift the oven properly could result in personal

injury or damage to the product.

WARNING

CAUTION: Do not remove the shipping base

or the shipping feet at the front lower cor-

ners of the oven. The shipping feet will

protect the lower oven trim until the oven is

inserted into the cabinet cutout.

REMOVING & REINSTALLING THE OVEN DOOR

To remove the oven door:

1. Install a pin in the hole of each oven door

hinge hanger.

2. Close the oven door as far as the two pins

will allow.

3. Grasp the sides of the door and lift the door

until it stops, then pull the hinge hangers

out of the slots.

To reinstall the oven door:

1. Grasp the sides of the door and tilt it back

at a slight angle, then insert the hinge

hangers into the hinge slots as far as they

will go.

2. Rotate the top of the door towards the

oven so the hinge hangers fit onto the

support pins.

3. Close the oven door as far as the pins will

allow, and make sure that the hinge hang-

ers are fully seated on the support pins. If

they are not seated properly, the door will

not close tightly and may be off-center. To

seat the hinge hangers, open the door

slightly, and push in on the bottom until the

hangers are fully seated.

4. Open the oven door to its fully open posi-

tion and remove the two hinge hanger

pins.

5. Close the oven door completely and check

it for proper operation and alignment.

Shipping Foot

Slot

Hinge Hanger

Door Pin Into Hinge Hanger Hole

Door Pin

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 58 59

Commentaires sur ces manuels

Pas de commentaire