Whirlpool YMT8066SE Manuel d'utilisateur télécharger pdf (Page 6)

6

Power

supply

cord

Exhaust vents

(on bottom in front)

Air intake

openings

Installation Instructions

Before you begin operating the oven, carefully read the following instructions.

1. Empty the microwave oven and clean

inside it with a soft, damp cloth. Check

for damage such as a door that isn’t lined

up correctly, damage around the door, or

dents inside the oven or on the exterior.

If there is any damage, do not operate the

oven until an authorized Whirlpool service

technician has checked it and made any

needed repairs.

2. Put the oven on a cart, counter, table,

or shelf that is strong enough to hold the

oven and the food and utensils you put

in it. (The control side of the unit is

the heavy side. Use care when han-

dling the oven.) The weight of the oven

is about 40 lbs (18kg). The microwave

oven should be at a temperature above

50°F (10°C) for proper operation.

NOTE: You can fasten your microwave oven

under a cabinet by using the proper trim kit.

See “Microwave oven features” in the

“Getting to Know” section.

wWARNING

Fire Hazard

Do not install the oven next to or

over a heat source without a UL or

CSA approved trim kit.

Doing so can result in death, fire,

or electrical shock.

NOTE: Do not block the exhaust vents or

rear air intake openings. Allow a few inches

of space at the back of the oven where the

intake openings are located. Blocking the air

intake openings and exhaust vents could

cause damage to the oven and poor cooking

results. Make sure the microwave oven legs

are in place to ensure proper airflow. If vents

are blocked, a sensitive thermal safety

device automatically turns the oven off. The

oven will not work until it has cooled enough.

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

Commentaires sur ces manuels

Pas de commentaire