Whirlpool ADPU 7443 WH Mode d'emploi

Naviguer en ligne ou télécharger Mode d'emploi pour Lave-vaisselle Whirlpool ADPU 7443 WH. Whirlpool ADPU 7443 WH Instruction for Use [en] [es] [it] [pt] Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
EN -1-
Chart
(see at right for options description)
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off it
drains any possible liquids from dishwasher
(1 minute process).
If the indicator flashes repeatedly, see page 6 -
chapter “What to do if...”.
START/RESUME BUTTON
Push this button to start the selected program:
the indicator lights up and goes off at the end of the
program. When the door is opened during a
washing cycle, the cycle is temporarily paused:
the Start indicator blinks. To resume the cycle
close the door and push Start button again.
PROGRAM SELECTION
BUTTON
Push “Programs” button
(repeatedly) until the indicator
of the required program lights
up (see “Table of programs”
below).
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary depending on
conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the
EN/Standard loading comparison test and other tests, contact the following address: “contact@whirlpool.com”.
3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.
* Power consumption in: Left-on mode: 0.70 W / Off-mode: 0.40 W.
Table of programs
Deter-
gent
Consumption
Drying
Phase
P
Programs
Available
options
Loading instructions
Litres kWh
Minutes
1)
1
Auto Sensor 50°-65°C
Delay
Antibacterial
rinse
Recommended program for
routine washes, with dried-on
food (e.g. EN 50242).
X 7-15 1.00-1.70 70-172 Full
2
Pre-Wash cold
Delay Crockery to be washed later. 4.0 0.01 14-16 NO
3
Rapid 45°C
Delay
Lightly soiled crockery, with no
dried-on food.
X 11.0 0.85 30-50 NO
4
Eco
2)
50°C
Delay
Antibacterial
rinse
Normally soiled crockery.
Standard program the most
efficient in terms of its combined
energy and water consumption .
X 12.0 1.02 170 Full
5
Intensive 65°C
Delay
Antibacterial
rinse
Recommended program for
heavily soiled crockery, especially
suitable for pans and saucepans.
X 15.0 1.60 165-175 Full
5019 300 00740
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS
QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Options and display description
SALT INDICATOR
When lit (at the end of the
cycle), the salt reservoir
needs to be refilled.
DELAYED START
BUTTON
The wash cycle can be
programmed to start
after 2, 4 or 8 hours.
Then press the Start
button. The wash
program will start after
the set time.
RINSE AID INDICATOR
When lit (at the end of the
cycle), the rinse aid
dispenser needs to be
refilled.
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY
BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
ANTIBACTERIAL RINSE
3)
This function activates an
antibacterial rinse at the end
of the wash cycle,
guaranteeing a further
reduction of bacteria. Press
the button to activate or
deactivate the function. This
function can be used with
the programs indicated in
the table of programs. The
dishwasher door must be
kept shut for the entire
duration of the program in
order to guarantee
reduction of bacteria. If the
door is opened the indicator
lamp starts flashing.
TABLET SETTING
This setting allows to optimize the cycle performances
according the type of detergent used.
Push the Tablet button for 3 seconds (until the indicator
lights up) if you are using the combined detergents in
tablet (rinse aid, salt and detergent in 1 dose).
If you are using powder detergent or liquid detergent,
the Tablet indicator on the control panel has to be off.
Quick reference guide
Whirlpool is a registered trademark of Whirlpool USA
Vue de la page 0
1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - 5019 300 00740

EN -1-Chart(see at right for options description)CANCEL/OFF BUTTONPush this button to switch off the control panel.If pressed when a program is runnin

Page 2 - Daily check

EN -2-First time use5 78614109231- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pan

Page 3 - Daily use

EN -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Page 4 - How to load the racks

EN -4-How to load the racksD - OPENLOWER RACK - depending on the model4A - Adjustable flaps (2 or 4): in horizontal position for cups / long utensils

Page 5 - Maintenance and care

EN -5-Wash cycleSelect program67Maintenance and careMaintenance and careOverview of programsThe max. possible number of programs is illustrated in the

Page 6 - What to do if

EN -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Page 7

EN -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit - Use tablets for soft water. - Set “Tablet” option

Page 8

EN -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A

Commentaires sur ces manuels

Pas de commentaire