Whirlpool GSF 6930 WH PC Mode d'emploi télécharger pdf

-1-

Chart

PROGRAM SELECTION

BUTTON

Push “Programs” button

(repeatedly) until the indicator

of the required program lights

up (see “Table of programs”

below).

(see at right for options description)

START/RESUME BUTTON

Push this button to start the selected program: the

indicator lights up and goes off at the end of the

program.

When the door is opened during a washing cycle,

the cycle is temporarily paused: the Start indicator

blinks. To resume the cycle close the door and

push Start button again.

CANCEL/OFF BUTTON

Push this button to switch off the control panel.

If pressed when a program is running it cancels the

program ongoing draining water for 1 minute (0:01

is shown into the display).

If pressed when the dishwasher is switched off, it

drains any possible liquids from dishwasher

(1minute process).

1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional

options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the

appliance’s automatic calibration system.

2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the

EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

Table of programs

Deter-

gent

Consumption

Programs

Available

options

Loading instructions

Litres kWh

Minutes

Sensor 40-70°C

Delay

Multizone

Power Clean

Normally or heavily soiled crockery,

including pots and pans. None soaking

or hand pretreatment is needed. In

addition hygiene of the complete

loading is ensured with this program.

X 7-14 1.00-1.80 70-185

Pre-Wash cold

Delay

Multizone

Crockery to be washed later. — 4.0 0.03 14

Glasses 40°C

Delay

Multizone

Light soiling, for example glasses and

cups.

X 10.0 0.85 100

Quickwash 45°C

Delay

Multizone

Lightly soiled crockery, with no

dried-on food.

X 11.0 0.80 30

Bio Normal

50°C

Delay

Multizone

Power Clean

Normally soiled crockery. X 12.0 1.05 150

Daily 60°C

Delay

Multizone

Normally to heavily soiled crockery. X 13.0 1.25 120

5019 496 01671GSF 6930 PC

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ

THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

Options and display description

SALT INDICATOR

When lit (at the end of the cycle),

the salt reservoir needs to be

refilled.

RINSE AID INDICATOR

When lit (at the end of the cycle),

the rinse aid dispenser needs to

be refilled.

WASH TIME DISPLAY

Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates

the time remaining until program start (h.00) - below 1h (0:min).

If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.

MULTIZONE

Allows you to choose the washing

zones. Press this button (repeatedly)

to select the wash zones:

both racks

only lower rack

only upper rack

- indicator lits

TABLET SETTING

This setting allows to

optimize the cycle

performances according

the type of detergent

used. Push the Tablet

button for 3 seconds (until

the indicator lights up) if

you are using the

combined detergents in

tablet (rinse aid, salt and

detergent in 1 dose). If you

are using powder

detergent or liquid

detergent, the Tablet

indicator on the control

panel has to be off.

DELAYED START

BUTTON

Push the button

(repeatedly) to delay the

start of the program.

Adjustable from 1 to 24

hours. With each press of

the button, the delayed

start indicator increases

by one hour and after 24

restarts from 0. Then

press the START button.

The dishwasher will start

after the set time.

POWER CLEAN

Thanks to the additional power jets

this option provides a more intensive

and powerful wash in the lower rack,

in the specific area. This option is

recommended for washing pots and

casseroles (see page 4). Press this

button to activate Power Clean (the

indicator lights up).

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING

ANY BUTTON EXCEPT CANCEL/OFF BUTTON.

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES

AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

Quick reference guide

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - 5019 496 01671GSF 6930 PC

GB -1-ChartPROGRAM SELECTION BUTTONPush “Programs” button (repeatedly) until the indicator of the required program lights up (see “Table of programs”

Page 2 - Daily check

GB -2-First time use1- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the panel9- filters10-

Page 3 - Daily use

GB -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Page 4 - How to load the racks

GB -4-How to load the racksE - OPENHow to load LOWER RACK4A - Glass-holder for long stem glasses: it can be adjusted in 2 different positions accordin

Page 5 - Maintenance and care

GB -5-Switching off the appliance. Everything o.k. ...Wash cycleSelect program678Exercise caution when opening the door: beware of hot steam.Press the

Page 6 - What to do if

GB -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Page 7

GB -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit- Use tablets for soft water. - Set “Tablet” option;

Page 8

GB -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A