Whirlpool ADG 6500 IN Mode d'emploi télécharger pdf (Page 6)

Before cleaning or carrying out maintenance, switch off the appliance and turn off the water tap.

Cleaning the outside of the appliance:

To clean the outside of the appliance, use a neutral detergent and a damp cloth.

Clean the control panel using a damp cloth alone.

Do not use abrasive detergents.

Cleaning the inside of the dishwasher:

Regularly wipe the door seal and inside of the door with a damp cloth to remove any food residue.

Upper spray arm:

1. Unscrew the nut by turning it counter-clockwise (A) and detach

the spray arm by pulling it downwards (B).

2. Rinse the nozzles.

3. To refit the spray arm, align it and then tighten the nut by turning

it clockwise, taking care not to bend the arm.

The nut should be tightened until you hear it click!

Make sure the spray arm rotates freely.

Lower spray arm:

1. Remove the spray arm by pulling it upwards (C).

2. Rinse the nozzles.

3. To remount the spray arm, align it with the mounting and insert it

by pushing it down.

Make sure the spray arm rotates freely.

Cleaning the filters:

1. Rotate the microfilter counter-clockwise (E) and extract it (F).

2. Push the middle filter from underneath to remove it from the

microfilter (G).

3. Separate the filters (I) and (H), lightly squeezing the filter (I) at the

reference arrows on the part and remove the filter (H).

4. Extract the central steel filter (J).

5. Clean all filters under running water.

Check that no impurities are left inside the dishwasher!

5. Reassemble the microfilter (H + I + G), replace the central steel

filter (J) and refit the microfilter assembly.

The filters must be installed correctly to ensure good wash

results!

CARE AND MAINTENANCE

IHG

1 2 3 4 5 6

Pas de commentaire

Whirlpool ADG 6500 IN Mode d'emploi Page 6