Whirlpool ADP 2300 WH Mode d'emploi télécharger pdf

-1-

Chart

PROGRAMME

SELECTION BUTTON

Push “Programs” button

(repeatedly) until the indicator

of the required programme

lights up (see “Table of

programmes” below).

START/RESUME BUTTON

Push this button to start the selected programme:

the indicator lights up and goes off at the end of the

programme. When the door is opened during a

washing cycle, the cycle is temporarely paused: the

Start indicator blinking. To restart the cycle close

the door and push Start button again.

BUTTON

Push this button to switch on or switch off the control panel.

If pressed when a programme is running it cancels

the programme ongoing.

If the indicator flashes repeatedly, see page 5 -

chapter ”What to do if ...”.

1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions

(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible

with sensor programmes as a result of the appliance’s automatic calibration system.

2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: fo

detailed information on the EN/Standard loading comparison test and other tests, contact the following address:

“[email protected]”.

Table of programmes

Deter-

gent

Consumption

Programmes Loading instructions

Litres kWh

Minutes

Pre-Wash cold

Crockery to be washed later. — 5.0 0.02 10

Quickwash 40°C

Lightly soiled crockery, with no dried-

on food.

X 13.0 0.70 30

Eco

50°C

Normally soiled crockery. X 15.0 1.05 150

Intensive 70°C

Recommended programme for heavily

soiled crockery, especially suitable for

pans and saucepans.

X 17.0 1.65 145

Half Load 50°C

Ideal for washing a half load of lightly or

normally soiled crockery.

X 13.0 1.00 130

5019 396 01823ADP 2300

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ

THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING

ANY BUTTON.

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES

AUTOMATICALLY AFTER 30 SECONDS IF ANY CYCLE IS STARTED.

Quick reference guide

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - 5019 396 01823ADP 2300

GB -1-ChartPROGRAMME SELECTION BUTTONPush “Programs” button (repeatedly) until the indicator of the required programme lights up (see “Table of progra

Page 2 - Daily check

GB -2-First time use1- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the panel9- filters10-

Page 3 - Daily use

GB -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Page 4 - How to load the racks

GB -4-How to load the racksE - OPEN(depending on the model)F - Foldable plate holders: They can be folded down to load potsorG - Fixed plate holdersH

Page 5 - Maintenance and care

GB -5-Switch off the appliance Everything o.k. ...Wash cycleSelect programmeQuick, permanent or alternating678Exercise caution when opening the door:

Page 6 - What to do if

GB -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Page 7

GB -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit- Use tablets for soft water. - Set “Tablet” option;

Page 8

GB -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A