Whirlpool oortable spa Manuel d'utilisateur Page 24

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 43
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 23
www.clearcreekspas.com
www.clearcreekspas.com
Activate the waterfall feature by first turning on the
JETS, HTR/FILTER, or FILTER function, then rotate
downward the flow control lever located on the left side
of the spout. Use this lever to adjust the amount of water
flowing through the Water Rainbow spout. The
waterfall effect will be greatest in the JETS mode.
Turning off the flow at the fully adjustable jets will
dramatically increase the Water Rain- bow flow.
CAUTION: The water circulating through the
Water Rainbow spouts is not fresh water and
therefore is not suitable for drinking.
WATER RAINBOW SPOUT
Air Blower
The Quantum Plus features a built-in air blower and
factory drilled air holes in the seats of the spa.
The blower sends air to a channel located under the
spa’s seats; this air is distributed through the air holes, and
as the pressurized air is released from the holes, tiny
bubbles are formed. These bubbles travel upward through
the water and expand until they reach the surface and burst.
The exciting visual effect of the bursting bubbles contrib-
utes to the overall hydromassage experience.
Activate the blower by pushing the ACC switch.
Filtration
When you are ready to leave the spa, push the SYSTEM
switch button to turn off the whirlpool. Then select the HTR/
FILTER mode. Adjust the TEMP CONTROL knob to the
temperature at which you want the water maintained. In
this way, the water will be filtered when the heater goes on
to maintain the temperature. Running the filter pump for at
least two hours per day is sufficient. Another way to be sure
the water will be filtered is to turn the SYSTEM off and set
the timer in the System Control Module to turn the system
on at a preset time everyday. Maintain the waterlevel to the
indicator mark on the skimmer/filter frame. (See page 8 for
instructions on setting timer.)
11
Vue de la page 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 42 43

Commentaires sur ces manuels

Pas de commentaire