Whirlpool AWM 5100 Mode d'emploi télécharger pdf (Page 14)

INSTALLATION

Remove the transit bolts

Slacken the four bolts with the spanner supplied.

Unscrew the bolts by hand.

Holding the bolt head, pull each bolt through the wide

part of the holes.

Close the holes with the plastic covers supplied; insert

the covers in the wide part of the hole and slide them

toward the narrow part until they click into place.

Keep the transit bolts for future use.



Whenever the appliance is transported, the transit bolts

must be refitted:

Pry off the plastic covers with a screwdriver, slide them

in the opposite direction of the arrow and remove.

Insert the transit bolts, performing the steps for

removal in reverse order.

Adjust the feet

If the floor is uneven, adjust the levelling feet as required

(do not insert pieces of wood etc. under the feet):

Slacken the locknut using the spanner supplied.

Adjust the height of the foot, turning it by hand.

Tighten the locknut by turning it anti-clockwise towards

the appliance casing.

If the appliance is to be installed on a wooden floor,

distribute the weight by placing it on a 60 x 60 cm sheet

of plywood at least 3 cm in thickness.

Secure the plywood sheet to the floor.

1 2 ... 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Whirlpool AWM 5100 Mode d'emploi Page 14