Whirlpool CED9060AW Manuel d'installation télécharger pdf (Page 23)

1. Check the electrical requirements. Be sure that you have the

correct electrical supply and the recommended grounding

method. See “Electrical Requirements.”

2. Check that all parts are now installed. If there is an extra part,

go back through the steps.

3. Check that you have all of your tools.

4. Dispose of/recycle all packaging materials.

5. Plug into a grounded outlet, or connect power.

LEVELING

6. Check dryer operation. Close dryer door. Insert coins in slide

and press slide in slowly. Select the Whites and Colors cycle

and let the dryer run for at least ve minutes.

NOTE: Dryer door must be closed for dryer to operate.

7. Open the dryer door. Check that the inside of the dryer is

warm. If the burner does not ignite and you can feel no heat

inside the dryer, shut off dryer for ve minutes. Check that

all supply valve controls are in “ON” position and that the

electrical cord is plugged in. Repeat ve-minute test.

8. If drying time is too long, make sure that the lint screen

is clean and that there are no obstructions to airow

in the dryer vent system.

9. Restart the dryer and allow it to complete a full cycle to make

sure it is working properly.

2. Grip dryer from top and rock back and forth, making sure all

four feet are rmly on oor. Repeat, rocking dryer from side

to side. If dryer rocks, adjust leveling feet.

3. If dryer is not level, turn the leveling feet counterclockwise

to lower the dryer or clockwise to raise the dryer. Recheck

levelness of dryer and that all four feet are rmly in contact

with the oor. Repeat as needed.

HELPFUL TIP: You may want to prop up front of dryer about 4"

(102 mm) with a wood block or similar object that will support

weight of dryer.

COMPLETE INSTALLATION

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 59 60

Pas de commentaire

Whirlpool CED9060AW Manuel d'installation Page 23