
GB11
IMPORTANT: the installer is responsible for any damage or injury resulting from
incorrect installation.
To guarantee correct operation, the appliance must be installed on a perfectly flat
surface.
For cut-out dimensions, see the figure below.
Dimensions in mm
For flush mounted installation or setting into a marble worktop, contact
the After-sales Service for the installation kit and necessary instructions.
• 4812 310 19277 Installation kit for marble worktop;
• 4801 211 00112 Installation kit for flush fitted worktop.
To guarantee correct operation, the appliance must be installed on a perfectly flat
surface.
The worktop must be 30-60 mm thick.
If necessary, cut the kitchen unit and worktop to fit before installing the hob.
Clean the cutout of any remaining dust that could compromise appliance
operation.
If a column unit is installed adjacent to the hob, leave a distance of at least 100
mm from the edge of the hob.
1. Position the clips (A) in the spaces provided on the hob trim (Fig.3) if not
already positioned.
2. Measure the centre point of the vertical sides of the cut-out (Fig. 1)
3. Fit the brackets (C) in the centre of the vertical sides, aligning the upper
edge of the brackets so that they are flush with the worktop surface (Fig.2).
4. Fix the brackets with the 4 screws supplied (B) using the holes provided.
5. Insert the hob in the cutout, making sure the clips (A) are secured in the
spaces provided (Fig.4).
Fig. 1
Fig.2
Fig.3
Fig.4
Undercounter oven installation
• If an oven (which must be of our manufacture) is to be installed under the
hob, ensure it is equipped with a cooling system and observe the distances
given in the figure to the side.
• There must be nothing between the cooktop and the oven (cross rails,
panels, brackets, etc.).
INSTALLATION AND FIXING
ASSEMBLY
490
+2
0
580
510
483
553
min. 50
52
+1
0
560
+2
0
R min. 6,5
max. 8
C
B
A
5mm
Commentaires sur ces manuels