Whirlpool GOA 9523/WH Mode d'emploi télécharger pdf (Page 3)

To secure the hob, use the brackets (A) provided with it. Fit the brackets into the relevant bores shown by the arrow and fasten them by means of their screws

inaccordancewiththethicknessoftheworktop(seethefollowinggures).

Top 20 mm Top 40 mm

Top 30 mm Top 60 mm

ADJUSTMENT TO DIFFERENT TYPES OF GAS

WARNING

This operation must be performed by a qualied technician.

Iftheapplianceisintendedtooperatewithadierentgasfromthegastypestatedontheratingplateandinformationlabelonthetopofthehob,changethe

injectors.

Remove the information label and keep it with the instructions booklet.

Use pressure regulators suitable for the gas pressure indicated in the Instruction:

• thegasinjectormustbechangedbyAfterSalesServiceoraqualiedtechnician;

• injectornotsuppliedwiththeappliancemustbeorderedfromAfterSalesService;

• adjust the minimum setting of the taps.

NOTE: when liquid petroleum gas is used (G30/G31), the minimum gas setting screw must be tightened as far as it will go.

IMPORTANT: should you experience diculty in turning the burners knobs, please contact the After Sales Service for the replacement of the burner

tap if found to be faulty.

IMPORTANT: when gas cylinder is adopted, the gas cylinder or gas container must be properly settled (vertical orientation).

REPLACING THE INJECTORS (see the injector table in the Instruction)

• Remove grids (A).

• Extractburners(B).

• Using a socket spanner of the appropriate size unscrew the injector (C), unscrew the injector

to be replaced.

• Replace it with the injector suitable for the new type of gas.

• Re-assemble the injector in (D).

• If you have a multiple crown burner use side spanner to replace the injector (E).

Beforeinstallingthehob,remembertoaxthegascalibrationplatesuppliedwiththeinjectorsin

suchawaythatitcoverstheexistinginformationrelatingtogascalibration.

ADJUSTING MINIMUM GAS SETTING OF TAPS

To ensure that the minimum setting is correctly adjusted, remove the knob and proceed as follows:

• tightenscrewtoreducetheameheight(-);

• loosenscrewtoincreasetheameheight(+).

Theadjustmentmustbeperformedwiththetapinminimumgassettingposition(smallame) :

• theprimaryairoftheburnersdoesnotneedtobeadjusted;

• atthisstage,lightuptheburnersandturntheknobsfrommaxposition to minimum position

tocheckamestability.

Uponcompletionofadjustment,resealusingsealingwaxoranequivalentmaterial.

1 2 3 4 5 6 7

Commentaires sur ces manuels

Pas de commentaire

Whirlpool GOA 9523/WH Mode d'emploi Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Whirlpool GOA 9523/WH