Whirlpool CLHB 11 IX Mode d'emploi télécharger pdf (Page 4)

GB2

- After use, make sure the knobs are in off position and close the main gas supply cock or the gas cylinder valve.

- Overheated oils and fats catch fire easily. Always remain vigilant when cooking foods rich in fat, oil or alcohol (e.g.

rum, cognac, wine).

- Keep the packaging materials out of the reach of children.

- Before cleaning or maintenance wait for hob to cool down.

After unpacking the hob, make sure that it has not been damaged during transport. In the event of problems, contact the

dealer or your nearest After-sales Service.

These instructions are only valid for the countries whose symbols is given on the data plate (under the hob).

TECHNICAL INFORMATION FOR THE INSTALLER

• This product can be embedded in a worktop 20 to 50 mm thick.

• If there is no oven beneath the hob, insert a separator panel that has a surface at least equal to the opening in

the work surface. This panel, that has to close completely the cutout in order to avoid any contact with the

bottom part of the hob, must be positioned at a maximum distance of 150 mm below the upper surface of

the work surface but, in no case less than 20 mm from the bottom of the hob. In the case that you intend to

install an oven beneath the hob, make sure that it is manufactured by Whirlpool and equipped with a cooling

system. The manufacturer declines all liability if another brand oven is installed beneath the hob.

• Before installation, make sure that:

- the local gas delivery conditions (nature and pressure) are compatible with the settings of the hob (see the

rating plate and injector table);

- the outer surfaces of the furniture or appliances adjacent to the hob are heat resistant according to local

regulations;

- this appliance is not connected to a fume exhaust device. It shall be installed in accordance with current

installation regulations. Particular attention shall be given to the relevant requirements regarding ventilation.

- combustion products are discharged outdoors through specific hoods or wall and/or window mounted electrical fans.

GAS CONNECTION

SAVE THESE INSTRUCTIONS

INSTALLATION

DANGER

This operation must be performed by a qualified technician.

• The gas supply system must comply with local regulations.

• You can find specific local regulations for some countries in the

paragraph “Reference to Local Regulations”. If no information

concerning your Country is given, please ask details to your Installer.

• The connection of the hob to the gas pipe network or gas cylinder must

be made by means of a rigid copper or steel pipe with fittings

complying with local regulations, or by means of a continuous-surface

stainless steel hose complying with local regulations. Interpose gasket

(B) in the elbow connection.The maximum length of the hose is 2 m.

• FOR BELGIUM ONLY: It is necessary to replace the elbow connection

(A) on the appliance, with the one supplied (if present).

IMPORTANT: if a stainless steel hose is used, it must be installed so as not

to touch any mobile part of the furniture. It must pass through an area

where there are no obstructions and where it is possible to inspect it on all

its length.

• After connection to the gas supply, check for leaks with soapy water.

Light up the burners and turn the knobs from max position to

minimum position to check flame stability.

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Whirlpool CLHB 11 IX Mode d'emploi Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Whirlpool CLHB 11 IX