Whirlpool BP 215 GS Mode d'emploi Page 13

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 44
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 12
55
55
5
Using the burnersUsing the burners
Using the burnersUsing the burners
Using the burners
To
ignite a burnerignite a burner
ignite a burnerignite a burner
ignite a burner, proceed as follows:
turn the relative knob counter-clockwise until the pointer is
on the high-flame symbol;
• press the knob down fully to activate the automatic gas
ignition ;
keep the knob pressed down for about 10 seconds with the
flame lit to allow the safety thermocouple to be heated;
release the knob, checking that the flame is stable. If it is
not, repeat the operation.
For minimum power, turn the knob towards the low flame
symbol. Intermediate positions are possible by putting the
knob anywhere between the high and the low flame symbol.
To turn off the burner, turn the knob clockwise to the off
position " " .
Adjusting the flame levelAdjusting the flame level
Adjusting the flame levelAdjusting the flame level
Adjusting the flame level
The flame level is adjusted by pressing the control knob and
turning it anticlockwise to the following positions:
Black circle = off
full flame = on
small flame = reduced gas flow
Important:Important:
Important:Important:
Important:
Do not activate the automatic ignition device for more than
15 consecutive seconds.
Difficulty in ignition is sometimes due to air inside the gas
duct.
If a burner flame accidentally goes out, the gas continues
to exit for a few moments before the safety device activates.
Turn the control knob to the off position and do not attempt
ignition again for at least 1 minute, thereby letting the gas
disperse, which could otherwise be a danger.
When the appliance is not in operation, check that the
knobs are in the off position " ". The main gas supply cut-
off cock should also be closed.
Using the burnersUsing the burners
Using the burnersUsing the burners
Using the burners
To obtain maximum efficiency from the burners, it is advisable
to only use pans with a diameter suitable for the burner being
used, so that the flame does not extend beyond the pan base
(see following table).
When a liquid starts boiling, it is advisable to turn the flame
down just enough to keep the liquid simmering.
Note When there is no electricity supply, the burners can
be lit with a match after turning the control knob to the
flame position.
To turn on one of the burners, place a lighted match or lighter
near the burner, press the knob all the way in and turn it anti-
clockwise to the "High" setting.
The “separate double flame” burnerThe “separate double flame” burner
The “separate double flame” burnerThe “separate double flame” burner
The “separate double flame” burner
This burner consists of two concentric burners which can
operate either together or separately.
Use of the double flame on the maximum setting gives a
very high power which reduces cooking times with respect
to conventional burners.
Moreover the double flame crown provides a more uniform
distribution of heat on the bottom of the pan, when using
both burners on minimum.
Pots and pans of all sizes can be used. In the case of the
smaller pots and pans we recommend the use of only the
internal burner.
There is a separate control knob for each of the “separate
double flame” burners.
The knob
marked
by the symbol operates the external
burner;
The knob
marked
by the symbol operates the internal
burner.
To turn on one of the rings, press the relative knob in all the
way and turn it anti-clockwise to the high setting . The burner
is fitted with an electronic igniter that automatically starts when
the knob is pressed in.
! Some models have a Double Flame burner. In this case, to
activate it, simply start by turning the knob so that it is aligned
with the symbol, then press it all the way in and hold it in
this position for approximately 6 seconds, until the automatic
device keeping the flame alight has heated up.
Since the burner is equipped with a safety deviceSince the burner is equipped with a safety device
Since the burner is equipped with a safety deviceSince the burner is equipped with a safety device
Since the burner is equipped with a safety device
"F""F"
"F""F"
"F", after lighting the burner keep the knob pressed in for
about 10 seconds to allow the device which keeps the flame
lit automatically to heat up.
To turn off a burner,To turn off a burner,
To turn off a burner,To turn off a burner,
To turn off a burner, turn the knob clockwise until it stops
(it should be on the “ ” setting).
To obtain the best results with the cooktop, several
fundamental rules should be followed while cooking or
preparing food. Use cookware with a flat bottom to make
certain that the pot sets properly on the cooking area.
Burner ø Cookware diameter (cm)
A. Auxiliary 6 – 14
B. Semi-Rapid 15 – 20
C. Rapid 21 – 26
D. Double Flame (DC DR internal) 10-14
D. Double Flame (DC DR external) 24-28
No
te
Vue de la page 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Commentaires sur ces manuels

Pas de commentaire