Whirlpool AKM 300/NB Mode d'emploi télécharger pdf (Page 7)

N C

M Y

INSTALLATION

Adaptation to different types of gas

If a gas different from that indicated on the label

is used, adapt the cooktop to this new function.

To replace the injectors consult the After-Sales

Service or a trained technician.

Injectors not supplied can be obtained from the

After-Sales Service.

1. Connect the cooktop to the on-off tap with a

tube which is suitable for the gas to be used

according to the regulations in force.

2. Replace the injectors (see Product Card),

proceeding as follows:

x Remove the grids (A).

x Extract the burner bodies (B).

x With a Ø 7 socket spanner (C) unscrew the

injector to be replaced.

x Replace with the injector provided for t he

new t ype of gas and reassemble in (D).

x Reassemble the burner bodies and the girds.

x Cancel the calibration indication (set for ....

gas) on the rating plate and position the

plate for the new type of gas near the gas

mains connection. This is to be found in the

bag of injectors supplied.

3. Select the type of gas (see Product Card) on

the basis of the injectors selected in point 3,

proceeding as follows:

x Make sure that the button

U

(see Product

Card) is OFF.

x Turn all the knobs to the minimum search

position.

x Keep button -

)

pressed and press button

+

=

3timeswithin 5 seconds then

release. The display shows the type of gas

adjusted in the factory or the last gas

selected.

If the buttons are not selected within 10

seconds, the procedure finishes without

changes.

x To select a different type of gas press

button +

=

choosing according to the

sequence C1 f C2 f C3 f C4 f C5.

f

x To save the type chosen, keep button -

)

pressed down and press button +

=

3 times within 5 seconds then release: the

saving is confirmed by an acoustic signal.

4. Automatically adjust the minima (see Product

Card).

58

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire