Whirlpool ACM795BA Mode d'emploi télécharger pdf (Page 12)

EN 22

Examples of good pot placement and bad pot placement:

When the exi cook function is selected, the booster and sixth sense functions cannot be used. If the timer is set, it will be displayed alongside the

hotplate display at the top.

CLEANING

WARNING

• Do not use steam cleaners.

• Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator (“H“) is not

displayed.

IMPORTANT: Do not use abrasive sponges or scouring pads. Their use could eventually ruin the glass.

• After each use, clean the hob (when it is cool) to remove any deposits and stains due to food residuals.

• Sugar or foods with a high sugar content damage the hob and must be immediately removed.

• Salt, sugar and sand could scratch the glass surface.

• Use a soft cloth, absorbent kitchen paper or a specic hob cleaner (follow the Manufacturer’s instructions).

TROUBLESHOOTING GUIDE

• Read and follow the instructions given in the section “Instructions for use“.

• Connect the hob to the electricity supply and check that the supply has not been shut off.

• Dry the hob thoroughly after cleaning it.

• If the hob cannot be switched off after using it, disconnect it from the power supply.

• If, when the hob is switched on, alphanumeric codes appear on the display, consult the following table for instructions.

ERROR CODE DESCRIPTION POSSIBLE CAUSES ERROR ELIMINATION

The hob switches off and after 30

seconds emits an acoustic signal

every 10 seconds.

Permanent pressure on the control

zone.

Water or kitchen utensils on the

control zone.

Clean the control zone.

C81, C82, C83

The control panel switches off

because of excessively high

temperatures.

The internal temperature of

electronic parts is too high.

Wait for the hob to cool down before

using it again.

F42 or F43 The connection voltage is wrong.

The sensor detects a discrepancy

between the appliance voltage and

that of the mains supply.

Disconnect the hob from the mains

and check the electrical connection.

F12, F21, F25, F36, F37, F40, F47,

F56, F58, F60, F61, F62, F63, F64

Call the After-sales Service and specify the error code.

1 2 ... 7 8 9 10 11 12 13 14 15

Commentaires sur ces manuels

Pas de commentaire

Whirlpool ACM795BA Mode d'emploi Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Whirlpool ACM795BA