Whirlpool ACM 846/BA/IXL Mode d'emploi télécharger pdf (Page 8)

EN7

Connecting to the terminal board

For electrical connection, use an H05RR-F cable as specified in the table below.

Connect the yellow/green earth wire to the terminal with the symbol .

This wire must be longer than the other wires.

1. Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block hinge (B).

2. Insert the power supply cable into the cable clamp and connect the wires to the terminal board as indicated in the diagram next to the terminal board itself.

3. Secure the power cable with the cable clamp.

4. Close the cover (C) and screw it on the terminal block with the removed screw - point (1).

Each time the cooktop is connected to the mains it carries out an automatic check which lasts several seconds.

If the hob already has a power cable, follow the instructions given on the label attached to the cable. Connect the appliance to the electricity supply by means of an all-pole

disconnect switch with minimum contact gap of 3 mm.

Control Panel Description

The control panel is equipped with touch controls: to use them, just press the corresponding symbol (a light touch is sufficient).

ELECTRICAL CONNECTION

WARNING

- Disconnect the appliance from the mains power supply.

- The appliance must be installed by a qualified technician who is fully aware of current safety and

installation regulations.

- The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the regulations

provided in this chapter.

- The power supply cable must be long enough to allow the hob to be removed from the worktop.

- Make sure the voltage specified on the appliance rating plate is the same as that of the domestic power supply voltage.

- Do not use extension cables.

During installation, make sure the appliance does not damage the power cable.

Wires Number x size

220-240 V ~ +

3 x 4 mm

220-240 V 3 ~ +

5 x 1.5 mm

380-415 V 3N ~ +

5 x 1.5 mm

380-415 V 2N ~ +

4 x 1.5 mm

INSTRUCTIONS FOR USE

230 V

380-415 V 3N ~ 220-240 V ~ 220-240 V ~ (AU and UK)

380-415 V 2N ~

220-240 V 3 ~ (Belgium only) 380-415 V 2N ~ (Holland only)

CBA

To select and activate the cooking zones

Hob ON/OFF

To set the minute

counter

To enable the hold

function

To select one of the automatic

functions

Slide touchscreen

To lock the control panel

To select the Flexi cook function

To switch the single

cooking zone OFF

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Commentaires sur ces manuels

Pas de commentaire

Whirlpool ACM 846/BA/IXL Mode d'emploi Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Whirlpool ACM 846/BA/IXL