Whirlpool FBCD 362 NF ED Mode d'emploi télécharger pdf

Always disconnect the appliance from the power supply before replacing the light bulb. Then

follow the instructions based on the type of light bulb for your product.

Replace the light bulb with one with the same features, available from the Technical Assistance

Service and authorised sellers.

Light type 1)

To remove the light bulb, unscrew it in an anti-clockwise direction, as

shown in the figure. Wait 5 minutes before reconnecting the appliance.

- traditional light bulb (max 25W)

- LED light bulb (with the same features)

only available from the Technical Assistance Service

Light type 2)

If the product has LED lights, as demonstrated in the figures below, contact the Technical

Assistance Service if you need a replacement.

LEDs last longer than traditional light bulbs, improve internal visibility and are environmentally-

friendly.

Clean the appliance occasionally with a cloth and a solution of warm

water and neutral cleaning agents specifically for cleaning the inside

of the refrigerator. Do not use abrasive cleaning agents. To ensure

the constant and correct flow of the defrosting water, regularly clean

the inside of the drain situated in the back wall of the refrigerator

compartment near the fruit and vegetable drawer using the utensil

provided (see figure).

Before carrying out any maintenance or cleaning, take the plug out of the socket or disconnect the

appliance from the power supply.

Connect the appliance to the power supply.

In models with electronics, a sound signal may be emitted, which means that the temperature

alarm has been activated: press the sound alarm off button. Where provided, position the

antibacterial anti-odour filter in the fan as demonstrated in the filter packaging.

Note: After turning the appliance on, you must wait for 4-5 hours for the correct storage

temperature to be reached for a normally filled appliance.

USING FOR THE FIRST TIME

MAINTENANCE AND CLEANING

OF THE APPLICANCE

REPLACING THE LIGHT BULB OR LED

(depending on the model)

Light bulb

LED light bulb

LED- strip

Dragon

et2

1 2 3 4 5 6

Résumé du contenu

Page 1 - OF THE APPLICANCE

1Always disconnect the appliance from the power supply before replacing the light bulb. Then follow the instructions based on the type of light bulb f

Page 2 - REFRIGERATOR COMPARTMENT

2Disconnect the appliance from the power supply, empty it, defrost it (if necessary) and clean it. Keep the doors slightly ajar to let air circulate i

Page 3 - FREEZER COMPARTMENT

3Model with separate freezer compartmentThe freezer compartment allows for the storage of frozen food (for the period indicated on the packaging) an

Page 4 - ACCESSORY

4STOP FROST SYSTEM (depending on the model)The STOP FROST SYSTEM (available depending on the model) facilitates the defrost procedure for the freezer

Page 5 - (depending on the model)

5"ZERO DEGREES" COMPARTMENT (depending on the model)The “Zero Degrees” compartment is specifically designed to maintain a low temperature a

Page 6 - TECHNICAL ASSISTANCE SERVICE

6Before contacting the Technical Assistance Service:Restart the appliance to check if the problem has been solved. If not, disconnect the appliance ag