Whirlpool Undercounter Dishwasher Manuel d'utilisateur télécharger pdf (Page 6)

To change door

panel color

NOTE: The opposite side of the door

color panel is a different color.

This panel is

narrower

than access

panel.

File or sand

edges of wood

Fg;;,+o avoid

Important: Run finaers alona

bottom bt retainer to c&k that-

retainer is lower than the lower door

frame.

To change access

color panel

(For models so equipped)

Personal Injury Hazard

Wear gloves and handle panels

carefully.

Cut metal edges may cause personal

injury or damage to other materials.

,”

Figure 5

Cut door panel to

clear access wnel

each end of

retainer at

bottom of door

when door is i’n

open position.

I I

Heavy-duty door springs must be used if

custom door panel weighs more than 4

pounds. Heavy-duty Door Springs Kit,

Part No. 4318050, is available from your

local dealer or parts supplier. Maximum

door weight is 8 pounds.

Wood access panel

This panel is wider than door panel.

k- 23-5/16”

Personal Injury Hazard

Wear gloves and handle panels

carefully.

Cut metal edges may cause personal

injury or damage to other materials.

panel. Then pull

retainer toward you. Set retainer aside.

Slide panel(s)

down to clear

console. Use both

hands to bow top and

bottom edge of door

panel(s). Remove

panel(s) from door.

Do Not remove

spacer.

Push up

with thumbs on

each end of

access panel

top trim to

4-7116

unsnap trim.

Remove top trim and set it aside.

Carefully

slide color

access panel

upwards and

remove. Do Not

remove spacer.

With desired

All edges routed to 7/32” thickness.

Top view

,7/32” thick

color facing out,

insert one side of

door panel(s) into

one side of door

frame.

With

desired color

facing out, bow

access panel

and insert into

access panel

Figure 6

Bow door panel(s)

and insert other side of

door panel(s) into door

Cut wood door and access panels

using specified dimensions. Make sure

wood grain direction matches cabinet

wood grain.

File or sand edges of wood panels

to avoid slivers.

Dishwasher is subject to some humidity.

Cover both sides and edges of wood

panels with moisture-resistant sealer.

frame.

frame. Slide panel down into groove

along bottom of access panel frame.

e control console ’

11 A

II /r

Push in on

access panel

frame. Tilt back of

trim down and slide into place. Snap

front of trim down to cover top edge of

access panel.

lower door

frame

door panel(s) near

the top and slide

panel(s) and

spacer up inside

bottom of control

console.

Push up at

each end of retainer

at bottom of door

panel. Then pull

retainer toward you. Set retainer aside.

To install

customized wood

panels in door and

access panel

Lift up and hold panel(s) and

Personal Injury Hazard

Wear gloves and handle panels

carefully.

Cut metal edges may cause personal

injury or damage to other materials.

spacer l/4” above lower door frame.

colorP

Dishwasher door panel and access

panel (if model is so equipped) can be

customized to match wood cabinets. A

standard l/4” (7/32” actual thickness)

wood panel can be used as is for

customtzing the door and access

panels.

A door panel thicker than 7/32”,

requires routing the top and bottom to a

7/32” thickness,

An access panel thicker than 7/32”,

requires routing all four edges to a 7/32”.

It is recommended that a cabinet-

maker cut the customized panels

because of the precise cuts required.

(See Figures 5 and 6.)

Wood door panel

Cut accurately for a snug fit between

door side frames. Note: Custom panel

fii between, Not inside frame.

w Slide panel(s) down

to clear console. Use both

hands to bow top and

bottom edges of color

door panel(s). Save color

panel(s) and spacer for

future use.

top of panel

under control

console

over lower edge

of door frame

while holding

door panel(s)

and spacer up.

between, not

inside, door frame

Insert top of wood door panel

between sides of door frame about 3”

below console. Rotate wood door panel

down against dishwasher door. Slide top

edge of wood door panel under bottom

edge of console. Press lower portion of

wood door panel in place between

sides of door frame.

Snap

retainer down

into place. Push down firmly along entire

length of retainer to make sure retainer is

secure. Slide door panel(s) down.

Panel E

1 2 3 4 5 6 7

Commentaires sur ces manuels

Pas de commentaire

Whirlpool Undercounter Dishwasher Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle Whirlpool Undercounter Dishwasher