Whirlpool WHES33 Spécifications télécharger pdf (Page 17)

Efficiency Icon

In the state of California: You must turn the Salt

Efficiency Feature ON. This may initiate more

frequent recharges. However, it will operate at

4,000 grains per pound of salt or higher.

SALT EFFICIENCY

When this feature is ON, the water softener will oper-

ate at salt efficiencies of 4000 grains of hardness per

pound of salt or higher (May recharge more often

using smaller salt dosage and less water). The sof-

tener is shipped with this feature set OFF.

1. Press and hold

the PROGRAM button until the

screen in Figure 35 is displayed. Once in this dis-

play, press the PROGRAM button once and one of

the two displays in Figure 36 is shown.

FIG. 34

Droplets indicate water

flow through softener

2. Press the r UP or s DOWN buttons to set ON or

OFF. When set to ON, the efficiency icon will be

displayed in the lower left hand corner of the nor-

mal run display.

FIG. 35

FIG. 36

SET SALT LEVEL

The water softener has a salt monitor indicator light to

remind you to add salt to the storage tank.

NOTE: You must set salt level each time salt is added

to the water softener.

To set this monitor system:

1. Lift the salt lid and level the salt in the storage tank.

2. The salt level decal, on the brinewell inside the

tank, has numbers from 0 to 8. Observe the high-

est number the leveled salt is at, or closest to.

3. Press the SET SALT LEVEL button until black

ovals correspond to the salt level number (See

Figure 32). At level 2 or below, the “Check Salt

Level" LED indicator will flash.

If you want to turn the salt monitor off, press the SET

SALT LEVEL button until “SALT LEVEL OFF” shows

in the display (See Figure 33).

FIG. 32

FIG. 33

Customizing Features / Options

(Models WHES30 & WHES33)

WATER FLOW INDICATOR

Whenever the softener has water flowing from the

outlet port, the display will show water droplets scroll-

ing down the right hand side of the screen (See

Figure 34). The faster the water flow, the faster the

droplets will flash.

POWER OUTAGE MEMORY

If electrical power to the water softener is lost, “mem-

ory'' built into the timer circuitry will keep all settings

for several hours. While the power is out, the display

is blank and the water softener will not regenerate.

When electrical power is restored, the following will

occur:

Reset the present time only if the display is flashing.

The HARDNESS and RECHARGE TIME never

require resetting unless a change is desired. Even if

the clock is incorrect after a long power outage, the

softener operates as it should to keep your water soft.

However, regenerations may occur at the wrong time

of day until you reset the clock to the correct time of

day.

NOTE: If the water softener was regenerating when

power was lost, it will now finish the cycle.

3. Press the PROGRAM button five times to return to

the normal run display.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Whirlpool WHES33 Spécifications Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Distributeurs d'eau Whirlpool WHES33