Whirlpool 900 Series Guide d'utilisation et d'entretien

COMPACTORSUse & Care GuideFor questions about features, operation/performance,parts, accessories or service, call: 1-800-253-1301.In Canada, call

10COMPACTOR USEHow Your Compactor WorksThe compacting ram is the part of the compactor which compresses the trash. The compacting ram does not go to t

11Style 2To start and stop the compactor1. To start the compactor: Turn the Key-Switch to ON. Press ON. Press START. The compactor will automatical

12COMPACTOR CAREYour new compactor is designed to give you many years of dependable service. However, there are a few things you are expected to do in

135. Wash the inside of the cabinet with a clean sponge or soft cloth and a mild detergent in warm water. Rinse and dry thoroughly with a soft cloth.6

14ASSISTANCE OR SERVICEBefore calling for assistance or service, please check “Troubleshooting.” It may save you the cost of a service call. If you st

15Notes

WHIRLPOOL CORPORATION MAJOR APPLIANCE WARRANTYONE YEAR LIMITED WARRANTYFor one year from the date of purchase, when this major appliance is operated a

2TABLE OF CONTENTSCOMPACTOR SAFETY...3INSTALLATION INSTRUCTIONS...

3COMPACTOR SAFETYYou can be killed or seriously injured if you don'timmediately follow instructions.You can be killed or seriously injured if you

4INSTALLATION INSTRUCTIONSInstaller: Leave Use and Care Guide with the homeowner.Homeowner: Keep Use & Care Guide for future reference and for loc

5Cutout dimensionsClearance dimensionsElectrical RequirementsRecommended Grounding MethodThis compactor is for use on a single phase, 115-volt, 60 Hz,

6Freestanding and Undercounter InstallationNOTE: Proper installation is your responsibility. Make sure you have everything necessary for correct insta

7 If the compactor is to be midway between “1” and “3,” place the retaining bracket mounting screws through “2.”7. Slowly lift the front slightly and

8Raised Panel: The outer section of panel must be ⁷⁄₃₂" (5.6 mm) thick to fit into the trim. Use the dimensions shown when designing raised panel

9Trimless Panel without HandleDimensionsUse these dimension drawings to create a custom panel for use without a trim kit. The panel should be ¹⁄₂"