Whirlpool 1188176 Spécifications télécharger pdf (Page 5)

Power Supply Cord

NOTE: Your unit's device may differ from the one shown.

To test your power supply cord:

1. Plug power supply cord into a grounded 3 prong outlet.

2. Press RESET (on some devices, a green light will turn on).

3. Press TEST (listen for click; Reset button will trip, and on

some devices, a green light will turn off).

4. Press and release RESET (listen for click; Reset button will

latch, and on some devices, a green light will turn on). The

power supply cord is ready for operation.

NOTES:

The Reset button must be pushed in for proper operation.

The power supply cord must be replaced if it fails to trip when

the test button is pressed or fails to reset.

A.Reset button

B. Testbutton

• Do not use the power supply cord as an off/on switch. The

power supply cord is designed as a protective device.

This room air conditioner is equipped with a power supply cord

required by UL. This power supply cord contains state-of-the-art

electronics that sense leakage current. If the cord is crushed, the

electronics detect leakage current and power will be

disconnected in a fraction of a second.

A damaged power supply cord must be replaced with a new

power supply cord obtained from the product manufacturer

and must not be repaired.

The power supply cord contains no user serviceable parts.

Opening the tamper-resistant case voids all warranty and

performance claims.

E_ectrica_ Shock Hazard

Plug into a grounded 3 prong out_et.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in

death, fire, or electrica_ shock.

INSTALLATIONINSTRUCTIONS

• Do not use sharp instruments, rubbing alcohol, flammable

fluids, or abrasive cleaners to remove tape or glue. These

products can damage the surface of your air conditioner.

• Handle air conditioner with care.

Excessive Weight Hazard

Use two or more people to move and install

air conditioner.

Failure to do so can result in back or other injury.

Remove packaging materials

• Remove and properly dispose of packaging materials.

Remove tape and glue residue from surfaces before turning

on the air conditioner. Rub a small amount of liquid dish soap

over the adhesive with your fingers. Wipe with warm water

and dry.

• Handle air conditioner with care.

• Be sure your air conditioner does not fall out of the opening

during installation or removal.

• Do not block the louvers on the front panel.

• Do not block air movement on the outside of the air

conditioner.

• The window frame assembly and side of structure must be

adequate to support weight of air conditioner.

1 2 3 4 5 6 7 8 9 10 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Whirlpool 1188176 Spécifications Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Climatiseurs à système divisé Whirlpool 1188176