Whirlpool MER8875WS Spécifications

INSTALLATION INSTRUCTIONS30" (76.0 CM) FREESTANDING ELECTRIC RANGESRANGE SAFETYTable of ContentsRANGE SAFETY ...

106. Use ³⁄₈" nut driver to connect the neutral (white) wire to the center terminal block post with one of the #10-32 hex nuts.7. Connect line 1

11Verify Anti-Tip Bracket Location1. On models with a storage drawer, pull drawer open to first stop position. Lift front of drawer to clear white whe

Moving the RangeWhen moving range, slide range onto cardboard or hardboard to avoid damaging the floor covering.If removing the range is necessary for

2INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation. Read and follow the instructions provided w

3Cabinet DimensionsCabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and 36" (9

4The fourth (grounding) conductor must be identified by a green or green/yellow cover and the neutral conductor by a white cover. Cord should be Type

5Install Anti-Tip Bracket1. Remove the anti-tip bracket that is taped in the storage drawer.2. Determine which mounting method to use: floor or wall.I

6Electrical Connection1. Disconnect power.2. Use Phillips screwdriver to remove the terminal block cover screw located on the back of the range.3. Rem

7 Position cord/conduit plate as shown in the following illustration. Replace cord/conduit plate and insert screws. Assemble a UL listed conduit co

83. Feed the power supply cord through the strain relief on the cord/conduit plate on bottom of range. Allow enough slack to easily attach the wiring

9Direct Wire Installation: Copper or Aluminum WireThis range may be connected directly to the fuse disconnect or circuit breaker box. Depending on you