Whirlpool AKM 260/IX/01 Mode d'emploi télécharger pdf (Page 4)

AFTER-SALES SERVICE

Before calling the After-Sales Service, make sure you can give the following information:

- type of fault or problem;

- exactmodel(writtenonthelabelafxedtotheinstruction/warranty);

- servicenumberthatfollowsthewordSERVICEontheratingplateunderthehobandonthelabelafxedtoinstruction/warranty;

- your complete address and phone number.

If any repairs are required, please contact an authorised After-Sales Service, as indicated in the warranty.

TROUBLESHOOTING GUIDE

If the hob will not operate correctly, before calling the After-Sales Service, refer to the Troubleshooting Guide to determine the problem.

1. The burner fails to ignite or the ame is not even

Check that:

• The gas or electrical supplies are not shut off and especially that the gas supply tap is open.

• The gas cylinder (liquid gas) is not empty.

• The burner openings are not clogged.

• The plug end is not dirty.

• All the burner parts have been positioned correctly.

• There are no draughts near the hob.

2. The burner does not stay lit

Check that:

• When lighting the burner, the knob has been pressed for enough time to activate the protection device.

• The burner openings are not clogged near the thermocouple.

• The end of the safety device is not dirty.

• The minimum gas setting is correct (see relevant paragraph).

3. The containers are not stable

Check that:

• Thebottomofthecontainerisperfectlyat

• The container is centered on the burner.

• Thegridshavenotbeenexchangedorpositionedincorrectly.

If after the above checks the fault still occurs, get in touch with the nearest After Sales Service.

CLEANING THE HOB SURFACE

Disconnect power before servicing.

• All the enamelled and glass parts should be cleaned with warm water and neutral solution.

• Stainless steel surfaces may be stained by calcareous water or aggressive detergents if left in contact for too long. Any food spills (water, sauce, coffee, etc.) should

be wiped away before they dry.

• Cleanwithwarmwaterandneutraldetergent,andthendrywithasoftclothorchamois.Removebaked-ondirtwithspeciccleanersforstainlesssteelsurfaces.

NOTE: clean stainless steel only with soft cloth or sponge.

• Donotuseabrasiveorcorrosiveproducts,chlorine-basedcleanersorpanscourers.

• Donotusesteamcleaningappliances.

• Donotuseammableproducts.

• Donotleaveacidoralkalinesubstances,suchasvinegar,mustard,salt,sugarorlemonjuiceonthehob.

CLEANING THE HOB PARTS

• Grids, burner caps and burners can be removed to be cleaned.

• Clean them by hand with warm water and non-abrasive detergent, removing any food residues and checking that none of the burner openings is clogged.

• Rinse and dry

• Retburnersandburnercapscorrectlyintherespectivehousings.

• When replacing the grids, make sure that the panstand area is aligned with the burner.

• Models equipped with electrical ignition plugs and safety device require thorough cleaning of the plug end in order to ensure correct operation. Check these items

frequently, and if necessary, clean them with a damp cloth. Any baked-on food should be removed with a toothpick or needle.

NOTE: to avoid damaging the electric ignition device, do not use it when the burners are not in their housing.

DECLARATION OF CONFORMITY

• This hob has been designed, constructed and marketed in compliance with:

 -safetyrequirementsof“Gas”Directive2009/142/EC(ex:EEC90/396);

 -safetyobjectivesofthe“LowVoltage”Directive2006/95/EC(whichreplaces73/23/EECandsubsequentamendments);

 -protectionrequirementsofEECDirective“EMC”2004/108/EC;

• ThisappliancemeetstheecodesignrequirementsofEuropeanregulationn.66/2014,inconformitytotheeuropeanstandardEN30-2-1

WARNING