Whirlpool WP 76/1 Mode d'emploi télécharger pdf

Whirlpool is a registered trademark of Whirlpool USA

5019 396 01136

WP 76

Before using the dishwasher, read the

installation and maintenance instructions carefully!

1) Programme data obtained in conformity with European standard EN 50242. Values may vary in relation to usage, e.g. different

loads, options, different sensor settings (only with sensor programmes), different water supply temperatures, as well as water

hardness and power supply voltage.

2) Reference programme for energy label in compliance with EN 50242. - Important information for Test Laboratories:

for

detailed information on the EN/Standard loading comparison test and other tests, contact the following address:

“nk_customer@whirlpool.com”.

1. OVERVIEW

On button

Off button

Delayed start button

Press the button repeatedly to delay the

start of the programme by 3, 6 or 9 hours.

Then press the START button. The

dishwasher will start at the set time.

Detergent setting upon initial use and when using a different type of

detergent

1. Select the third programme in the relative table.

2. Press the START button for approx. 7 sec. to change the display.

3. Using the START button, select the desired detergent:

“3h” = 2in1, “6h” = 3in1, “9h” = other combined action detergents

(in this way, the rinse aid and/or salt indicator is deactivated). All 3

LEDs light up = Powder detergent (factory setting).

4. Switch the appliance off and then switch it on again. The selected

detergent type will be indicated on the display by the

corresponding LEDs for approx. 3 seconds.

Programme selection button

Press the button repeatedly until the desired programme

indicator lights up.

Start button

Switches “on” when the dishwasher is operating.

Flashes when a fault occurs. Switches off at the end of

the programme.

START button RESET function:

Press this button for at least 2 seconds; the selected

programme and options are cancelled. Main failure

displays (repeated flashing of the START indicator lamp)

can be cancelled by RESETTING. Detailed instructions

are given in chapter 5 “What to do if...”.

Rinse aid level indicator and salt level indicator

These indicator lamps light up when rinse aid or salt

need to be added. Add just before starting a wash

programme.

Table 1.1.

Programme chart

Detergent

dispenser

Consumption

Programmes

Available

options

Loading instructions large small Litres kWh Minutes

Auto Sensor 50-65°C

Automatic programme

recommended for routine

washes, with dried-on food

(for example for EN 50242).

X X 11-16 1.10-1.50 100-130 ±

Quickwash 40°C

Lightly soiled crockery, with

no dried-on food.

X — 10.0 0.65 30 ±

Eco

50°C

Normally soiled crockery. X X 12.0 1.05 165 ±

Intensive 70°C

Recommended programme

for heavily soiled crockery,

especially suitable for pans and

saucepans.

X X 14.0 1.55 155 ±

Power Clean 70°C

Recommended programme for

heavily soiled crockery, especially

suitable for pans and saucepans.

Intensive wash with additional

water jets.

X X 16.0 1.80 220 ±

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - 1. OVERVIEW

Whirlpool is a registered trademark of Whirlpool USA5019 396 011361GBWP 76Before using the dishwasher, read the installation and maintenance instructi

Page 2 - 2. QUICK REFERENCE GUIDE

22. QUICK REFERENCE GUIDEDetailed instructions are given in the following pages, see also chapter “5. What to do if...”1. Switch on the applianceOpen

Page 3 - 3. HOW TO USE THE APPLIANCE

33. HOW TO USE THE APPLIANCEPROGRAMME SELECTIONPress the button or to bring up the desired programme on the display. The appliance must be switche

Page 4

43. HOW TO USE THE APPLIANCEc. How to adjust the rinse aid dosage regulatorThe rinse aid dosage can be adjusted to the detergent used. The lower the s

Page 5 - 3. USING THE APPLIANCE

53. USING THE APPLIANCELOADING THE RACKSTOP RACK - depending on modelLong utensils (kitchen knives) must be placed with the tips towards the appliance

Page 6

64. PRECAUTIONS AND GENERAL RECOMMENDATIONS1. PackingThe packaging materials are 100% recyclable and marked with the recycling symbol. .2. Removing t

Page 7 - 5. WHAT TO DO IF

75. WHAT TO DO IF...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults

Page 8

85. WHAT TO DO IF...Crockery and cutlery ... Possible causes/solutions...are not perfectly clean/have food residues- In the event of frequent use of t