EN -1-
Chart
(see at right for options description)
PROGRAM SELECTION
BUTTON
Push “P” button (repeatedly)
until selected program number
is shown on the display
(P1...Px) - see “Table of
programs” below.
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program.
When the door is opened during a washing cycle,
the cycle is temporarily paused: the Start indicator
blinks. To resume the cycle close the door and
push Start button again.
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute
(0:01 is shown into the display).
If pressed when the dishwasher is switched off,
it drains any possible liquids from dishwasher
(1 minute process).
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary
depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/
Standard loading comparison test and other tests, contact the following address: “
[email protected]”.
RECYCLING WATER SYSTEM: these programs save water in a dedicated tank.
A TANK CLEANING CYCLE (at least 45 min.) is automatically run every 30 cycles or after every power off, to assure the best product
conditions.
* Power consumption in: Left-on mode: 0.70 W / Off-mode: 0.40 W.
Table of programs
Deter-
gent
Consumption
Drying
Phase
Programs
Available
options
Loading instructions
Litres kWh
Minutes
1)
P1
Intellisence 40°-70°C
Delay
Multizone
Jet Clean
Use for normal soiled dishes with dried-on food.
Senses the level of soiling on the dishes and adjusts
the program accordingly. When the sensor is
detecting the soil level an animation appears in the
display and the cycle duration is updated. The Jet
Clean option is activated automatically with this
program. To deactivate, press the Jet Clean button on
the control panel.
X 7-15 1.00-1.70 70-172 Full
P2
Pre-Wash cold
Delay
Multizone
Crockery to be washed later. — 4.0 0.01 14-16 NO
P3
Glasses 40°C
Delay
Multizone
Light soiling, for example glasses and cups. X 10.5 0.85 105-114 Light
P4
Quick 45°C
Delay
Multizone
Lightly soiled crockery, with no dried-on food. X 11.0 0.85 30-50 NO
P5
Eco
2)
50°C
Delay
Multizone
Jet Clean
Normally soiled crockery.
Standard Program the most efficient in terms of its
combined energy and water consumption.
X 6.0 1.03 170 Full
P6
Daily 60°C
Delay
Multizone
Normally soiled crockery. X 11.0 1.30 80-95 Full
P7
Overnight
(39 dbA)
Delay
Multizone
Normally soiled crockery, gentle and
quiet thanks to the lower spray pressure (39 dBa).
X 10.0 1.20 290-299 Light
P8
2 in 1
Delay
Multizone
Jet Clean
This program is able to manage different wash intensity
for each rack. You can optimize loading and properly
wash different crockery in one cycle, loading delicate
items in upper rack and pots and pans in lower rack.
X 11.0 1.50 155-170 Full
5019 600 00194
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Options and display description
SALT INDICATOR
When lit (at the end of the cycle),
the salt reservoir needs to be
refilled.
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to
be refilled.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates
the time remaining until program start (h.00) - below 1h (0:min).
If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
MULTIZONE
Allows you to choose the washing
zones. Press this button (repeatedly)
to select the wash zones:
both racks
only lower rack
only upper rack
- indicator lits
JET CLEAN
Thanks to the additional power jets
this option provides a more intensive
and powerful wash in the lower rack,
in the specific area. This option is
recommended for washing pots and
casseroles (see page 4). Press this
button to activate Jet Clean (the
indicator lights up).
For non Jet Clean loading to achieve
best cleaning performances and
resources optimization, Jet Clean
should be switched off.
TABLET SETTING
This setting allows to
optimize the cycle
performances according
the type of detergent
used. Push the Tablet
button for 3 seconds (until
the indicator lights up) if
you are using the
combined detergents in
tablet (rinse aid, salt and
detergent in 1 dose). If you
are using powder
detergent or liquid
detergent, the Tablet
indicator on the control
panel has to be off.
DELAYED START
BUTTON
Push the button
(repeatedly) to delay the
start of the program.
Adjustable from 1 to 24
hours. With each press of
the button, the delayed
start indicator increases
by one hour and after 24
restarts from 0. Then
press the START button.
The dishwasher will start
after the set time.
Quick reference guide
Maytag is a registered trademark
(8 pages)
(8 pages)
(8 pages)
(8 pages)
(80 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels