Whirlpool GSXP 100 POWER Mode d'emploi télécharger pdf

5019 496 01042

GSXP 100 POWER

Before using the dishwasher, read the

installation and maintenance instructions carefully!

1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to

different loads, extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness

and power supply voltage.

2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories:

for more detailed information on the

EN comparison test and other tests, contact the following address: “[email protected]”.

3) The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with. Standard NF

EN 13697 - November 2001.

ON button

OFF button

Programme selection button

Press button P (repeatedly) until the required

programme number appears on the display.

Fault indication and wash time display

In normal operation it indicates the remaining time

(h:mm), whereas with “Delayed start” selected it

indicates the time remaining until programme start (hh).

In case of a fault indication “F..” –, consult the section “5.

What to do, in case of …!

Rinse aid level indicator and salt level indicator

They light up when rinse aid or salt need to be added.

Add just before starting a wash cycle.

Set the detergent

Press button P (repeatedly) to set the type of detergent used.

This deactivates the rinse aid and/or salt indicator.

Half Load/Multizone button

Load the

top

bottom

rack only.

Press once = wash

top rack

(the indicator/symbol lights up)

Press twice = wash

bottom rack

(the indicator/symbol

lights up)

Press 3 times =

Off

(Half load/Multizone deactivated).

When washing without the top rack, press the “Half load”

(i.e. “wash bottom rack”) button twice (the corresponding

indicator/symbol lights up).

Powder, gel, tablets (standard): indicator off

Detergent with rinse aid: left indicator

Detergent with salt + rinse aid: right indicator

Power Clean

High pressure with an additional jet for better washing

results and greater bottom rack load flexibility.

“Delayed start” button

Press the button (repeatedly) to delay the start of the

programme. Adjustable from 1 to 24 hours. With each

press of the button, the delayed start indicator increases by

one hour and after 24 restarts from 00. Then press the

START button. The dishwasher will start after the set time.

START button

The indicator lights up during operation, flashes when a

fault occurs, and goes off at the end of the programme.

RESET button - for programme change or indication of faults

Press this button to cancel a started programme and

selected extra functions. Press this button to cancel the

main fault indicators (F..); also refer to the section

“5. What to do, in case of...”. The programme can then

be selected and started.

Table 1.1.

Table of programmes

Detergent

dispenser

Consumption

Programmes

Selectable

extra

functions

Loading instructions large small Litres kWh Minutes

Sensor + 40-70°C

Normally or very dirty dishes,

including pots and pans.

X X 7-17 0.99-1.75 65-220 ±

Pre-Rinse cold

Dishes to be washed later. — — 4.0 0.03 14 ±

Hand wash 40°C

Slightly dirty items, e.g. glasses and

cups, with a lower pressure jet.

X — 10.0 0.85 125 ±

Rapid 40°C

Slightly dirty dishes, without dry

residuals.

X — 10.0 0.65 30 ±

Eco

50°C

Normally dirty dishes. Energy-saving

programme with prolonged drying.

X X 13.0 1.05 195 ±

Hygienic +

Normally or very dirty dishes, with

additional antibacterial action. An

interruption of the programme (e.g. due

to door opening) can compromise

elimination of germs.

X X 13.0 1.50 115 ±

Overnight 55°C

Normally dirty dishes, gentle and

quiet (39 dbA) thanks to the lower

pressure jet.

X X 13.0 1.20 290 ±

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - GSXP 100 POWER

5019 496 010421GBGSXP 100 POWERBefore using the dishwasher, read the installation and maintenance instructions carefully!1) Programme data obtained in

Page 2 - 2. QUICK REFERENCE GUIDE

22. QUICK REFERENCE GUIDEDetailed instructions are given in the following pages, see also chapter “5. What to do if...”1. Switch on the applianceOpen

Page 3 - 3. HOW TO USE THE APPLIANCE

33. HOW TO USE THE APPLIANCEPROGRAMME SELECTIONPress the button or to bring up the desired programme on the display. The appliance must be switche

Page 4

43. HOW TO USE THE APPLIANCEc. How to adjust the rinse aid dosage regulatorThe rinse aid dosage can be adjusted to the detergent used. The lower the s

Page 5

53. HOW TO USE THE APPLIANCEHOW TO LOAD THE RACKSUPPER RACK - depending on modelLong-handled utensils (kitchen knives) must be arranged with the sharp

Page 6

64. PRECAUTIONS AND GENERAL RECOMMENDATIONS1. PackingThe packaging materials are 100% recyclable and marked with the recycling symbol. .2. Removing t

Page 7 - 5. WHAT TO DO IF

75. WHAT TO DO IF...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults

Page 8

85. WHAT TO DO IF...Crockery and cutlery ... Possible causes/solutions...are not perfectly clean/have food residues- In the event of frequent use of t