Whirlpool ADP 1077 IX Mode d'emploi télécharger pdf (Page 7)

1. To open the dispenser, turn the cap to the "open" (left) arrow

and lift it out.

2. Pour the rinse aid into the dispenser, being careful not to overfill.

3. Replace the cap by inserting it aligned with the "open" arrow

and turning it to the closed (right) arrow.

NOTE

Clean up any rinse aid spilled during filling with an absorbent cloth

to avoid excessive foaming during the next wash. Don't forget to

replace the cap before you close the dishwasher door.

Adjusting the Rinse Aid Dispenser

The rinse aid dispenser has six or four settings. Always start with

the dispenser set on "4". If spots and poor drying are a problem,

increase the amount of rinse aid dispensed by removing the

dispenser lid and turning the dial to "5". If the dishes still are not

drying properly or are show spots, adjust the dial to the next setting

up until your dishes are spot-free. The recommended setting is "4".

(Factory value is "4".)

NOTE

Increase the dose if there are drops of water or lime spots on the

dishes after washing.

Reduce it if there are sticky whitish stains on your dishes or a bluish

film on glassware or knife blades.

Adjust setting

(Rinse)

1 2 3 4 5 6 7 8 9 10 11 12 ... 24 25

Pas de commentaire

Whirlpool ADP 1077 IX Mode d'emploi Page 7