Whirlpool ADP 1077 IX Mode d'emploi télécharger pdf (Page 5)

B. Loading Salt into the Softener

Always use salt intended for use with dishwashers.

The salt container is located beneath the lower rack and should be filled as explained below:

Attention

• Only use salt specifically designed for use in dishwashers! Every other type of salt not specifically

designed for use in a dishwasher, especially table salt, will damage the water softener. Damages caused

by the use of unsuitable salt are not covered by warranty, nor is the manufacturer liable for any

damages caused.

• Only fill with salt just before starting one of the complete washing programs. This will prevent any

grains of salt or salty water, which may have been spilled, remaining on the bottom of the machine for

any period of time, which may cause corrosion.

A. Remove the lower rack and then unscrew and remove the cap from the salt container (1).

B. Use a funnel to fill the salt container with about 1.5 kg of dishwasher salt, then please remove the salt

funnel from all production.

C. Fill the salt container with water. It is normal for a small amount of water to comeout of the salt

container (2).

D. After filling the container, screw the cap tightly back clockwise.

E. Usually, the salt warning light will stop being illuminated within 2-6 days after the salt container has

been filled with salt.

F. Immediately after pouring the salt into the salt container, a washing program should be started (we

suggest to use the soak or rapid program). Otherwise the filter system, pump or other important parts

of the machine may be damaged by salty water. This is not covered by warranty.

Note:

1. The salt container must only be refilled when the salt warning light on the control panel comes on.

Depending on how well the salt dissolves, the salt warning light may still be on even though the salt

container is filled.

If there is no salt warning light on the control panel (for some models), you can estimate when to fill

the salt into the softener by the cycles that the dishwasher has run.

2. In the event of salt spills, a soak or a rapid program should be run to remove the excessive salt.

Open

1 2 3 4 5 6 7 8 9 10 ... 24 25

Pas de commentaire

Whirlpool ADP 1077 IX Mode d'emploi Page 5