Whirlpool ADG 9527/1 Mode d'emploi

Naviguer en ligne ou télécharger Mode d'emploi pour Lave-vaisselle Whirlpool ADG 9527/1. Whirlpool ADG 9527/1 Instruction for Use Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
GB
-1-
Chart
(see at right for options description)
PROGRAMME SELECTION BUTTON
Press button “P” (repeatedly) until the required
programme number appears on the display (see
“Table of programmes” below).
START BUTTON
The indicator lights up during operation,
flashes when a fault occurs and goes off at
the end of the programme.
ON
BUTTON
OFF
BUTTON
FAULT INDICATION AND WASH TIME DISPLAY
In normal operation it indicates the remaining time (h:mm), whereas with
“Delayed start” selected it indicates the time remaining until programme
start (hh).
If “F..” appears on the display, see chapter “What to do if...”.
RESET BUTTON
For programme change or indication of faults.
Press this button to cancel a started programme and selected extra
options. Press this button to cancel the main fault indicators “F..”
also refer to the chapter “What to do if...”. The programme can then
be selected and started.
1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional
options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of
the appliance’s automatic calibration system.
2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on
the EN/Standard loading comparison test and other tests, contact the following address: “[email protected]”.
3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.
Table of programmes
Deter-
gent
Consumption
P
Programmes
Available
options
Loading instructions
Litres kWh
Minutes
1)
1
Pre-Wash cold
Delay
Multizone
Crockery to be washed later. 4.0 0.03 14
2
Quickwash 40°C
Delay
Multizone
Lightly soiled crockery, with no
dried-on food.
* Not recommended tablets
use.
X
*
11.0 0.80 30
3
Eco
2)
50°C
Delay
Multizone
Antibacterial
rinse
Normally soiled crockery.
Energy-saving programme.
X 12.0 1.05 165
4
Daily 60°C
Delay
Multizone
Antibacterial
rinse
Normally to heavily soiled
crockery.
X 13.0 1.25 120
5
Intensive 70°C
Delay
Multizone
Antibacterial
rinse
Recommended programme for
heavily soiled crockery,
especially suitable for pots and
pans.
X 14.0 1.55 155
5019 396 01783ADG 9527
Options and display description
BEFORE USING THE APPLIANCE FOR THE
FIRST TIME CAREFULLY READ THIS QUICK
REFERENCE GUIDE AND THE ASSEMBLY
INSTRUCTIONS! THE GUARANTEE IS NOT
APPLICABLE IF FAULTS ARE CAUSED BY
INCORRECT USE OF THE APPLIANCE.
HALF LOAD/
MULTIZONE
Allows you to choose
the washing zones.
Press this button
(repeatedly) to select
the wash zones:
both racks
only upper
rack
only lower
rack
ANTIBACTERIAL
RINSE
3)
This function activates
an antibacterial rinse at
the end of the wash
cycle, guaranteeing a
further reduction of
bacteria.
Press the button to
activate or deactivate
the function. This
function can be used
with those
programmes marked
with the relative
description in table.
The dishwasher door
must be kept shut for
the entire duration of
the programme in
order to guarantee
reduction of bacteria. If
the door is opened the
indicator lamp starts
flashing.
RINSE AID
INDICATOR
When lit, the rinse aid
dispenser needs to be
refilled.
SALT INDICATOR
When lit, the salt
reservoir needs to be
refilled.
SET THE
DETERGENT
Press this button
(repeatedly) to set the
type of detergent used.
Powder, gel
(standard)
Detergent
with rinse aid
Detergent
with salt +
rinse aid
RUNNING PROGRAMME
INDICATOR
A LED light projected on the
floor indicates that the
dishwasher is working.
DELAYED START
BUTTON
Press the button
(repeatedly) to delay
the start of the
programme.
Adjustable from 1 to 24
hours. With each press
of the button, the
delayed start indicator
increases by one hour
and after 24 resets
from 00. Then press
the START button. The
dishwasher will start
after the set time.
Quick reference guide
Vue de la page 0
1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - 5019 396 01783ADG 9527

GB -1-Chart(see at right for options description)PROGRAMME SELECTION BUTTONPress button “P” (repeatedly) until the required programme number appears o

Page 2 - Daily check

GB -2-First time use1- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the panel9- filters10-

Page 3 - Daily use

GB -3-Daily check23Rinse aid indicator (depending on model)The indicator lamp on the control panel lights up when RINSE AID NEEDS TO BE ADDED.dark: OK

Page 4 - How to load the racks

GB -4-How to load the racksHJ(depending on the model)G - Foldable plate holders: They can be folded down to load potsorH- Fixed plate holdersI - Cutle

Page 5 - Maintenance and care

GB -5-Switch off the appliance Everything o.k. ...Wash cycleSelect programmeQuick, permanent or alternating678Exercise caution when opening the door:

Page 6 - What to do if

GB -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faul

Page 7

GB -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit- Use tablets for soft water. - Set “Detergent type”

Page 8

GB -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap.Contact the Af

Commentaires sur ces manuels

Pas de commentaire