Whirlpool ADG 9100 FD Mode d'emploi télécharger pdf

-1-

Chart

(see at right for options description)

PROGRAMME SELECTION BUTTON

Press button “P” (repeatedly) until the

required programme number appears on

the display (see “Table of programmes”

below).

START BUTTON

The indicator lights up during operation,

flashes when a fault occurs and goes off at

the end of the programme.

BUTTON

OFF

BUTTON

FAULT INDICATION AND WASH TIME DISPLAY

In normal operation it indicates the remaining time (h:mm), whereas with

“Delayed start” selected it indicates the time remaining until programme

start (hh).

If “F..” appears on the display, see chapter “What to do if...”.

RESET BUTTON

For programme change or indication of faults.

Press this button to cancel a started programme and selected extra

options. Press this button to cancel the main fault indicators “F..”

also refer to the chapter “What to do if...”. The programme can then

be selected and started.

1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional

options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of

the appliance’s automatic calibration system.

2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on

the EN/Standard loading comparison test and other tests, contact the following address: “[email protected]”.

3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.

Table of programmes

Deter-

gent

Consumption

Programmes

Available

options

Loading instructions Litres Kwh

Minutes

Quickwash 40°C

Delay

Lightly soiled crockery, with no dried-

on food.

Not recommended tablets use.

13.0 0.65 30

Bio

50°C

Delay Normally soiled crockery. X 17.0 1.13 195

Intensive 70°C

Delay

Recommended programme for heavily

soiled crockery, especially suitable for

pots and pans.

X 17.0 1.75 150

Antibacterial

Delay

Normally or heavily soiled crockery,

with additional antibacterial wash.

Programme interruption (e.g. due to

door opening) can compromise

elimination of germs.

X 17.0 1.60 120

Half Load 50°C

Delay

Ideal for washing a half load of lightly

or normally soiled crockery.

X 13.0 0.90 130

5019 396 01760ADG 9100

Options and display description

BEFORE USING THE APPLIANCE FOR THE

FIRST TIME CAREFULLY READ THIS QUICK

REFERENCE GUIDE AND THE INSTALLATION

INSTRUCTIONS! THE GUARANTEE IS NOT

APPLICABLE IF FAULTS ARE CAUSED BY

INCORRECT USE OF THE APPLIANCE.

RINSE AID

INDICATOR

When lit, the rinse aid

dispenser needs to be

refilled.

SALT INDICATOR

When lit, the salt

reservoir needs to be

refilled.

SET THE

DETERGENT

Press this button

(repeatedly) to set the

type of detergent used.

Powder, gel

(standard)

Detergent

with rinse aid

Detergent

with salt +

rinse aid

DELAYED START

BUTTON

Press the button

(repeatedly) to delay

the start of the

programme.

Adjustable from 1 to 24

hours. With each press

of the button, the

delayed start indicator

increases by one hour

and after 24 resets

from 00. Then press

the START button. The

dishwasher will start

after the set time.

Quick reference guide

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - 5019 396 01760ADG 9100

GB -1-Chart(see at right for options description)PROGRAMME SELECTION BUTTONPress button “P” (repeatedly) until the required programme number appears o

Page 2 - Daily check

GB -2-First time use578623SEL141091- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pane

Page 3 - Daily use

GB -3-Daily check23Rinse aid indicator (depending on model)The indicator lamp on the control panel lights up when RINSE AID NEEDS TO BE ADDED.dark: OK

Page 4 - How to load the racks

GB -4-How to load the racksHJ(depending on the model)G - Foldable plate holders: They can be folded down to load potsorH- Fixed plate holdersI - Cutle

Page 5

GB -5-109678Overview of programmesThe max. possible number of programmes is illustrated in this overview. The corresponding programmes for your applia

Page 6 - What to do if

GB -6-What to do if...If a fault occurs, before restoring normal appliance operation contacting the After-sales Service, make the following checks to

Page 7

GB -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit- Use tablets for soft water. - Set “Detergent type”

Page 8

GB -8-What to do if...If, after carrying out the above checks, the fault persists, switch off the appliance, disconnect the mains plug and turn off th

Commentaires sur ces manuels

Pas de commentaire

Whirlpool ADG 9100 FD Mode d'emploi

Naviguer en ligne ou télécharger Mode d'emploi pour Lave-vaisselle Whirlpool ADG 9100 FD. Whirlpool ADG 9100 FD Instruction for Use Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle Whirlpool ADG 9100 FD