Whirlpool PY 640 T (IX)/HA Mode d'emploi télécharger pdf (Page 18)

! The position of the corresponding gas burner is

shown on every knob.

Gas burners

Each burner can be adjusted to one of the following

settings using the corresponding control knob:

• Off

Maximum

Minimum

To light one of the burners, hold a lit match or lighter

near the burner and, at the same time, press down

and turn the corresponding knob anti-clockwise to the

maximum setting.

Since the burner is fitted with a safety device, the

knob should be pressed for approximately 2-3

seconds to allow the automatic device keeping the

flame alight to heat up.

To light a burner, simply press the corresponding

knob all the way in and then turn it in the counter-

clockwise direction to the "High" setting, keeping it

pressed in until the burner lights.

! If a flame is accidentally extinguished, turn off the

control knob and wait for at least 1 minute before

trying to relight it.

To switch off the burner, turn the knob in a clockwise

direction until it stops (when reaches the “•” position).

Practical advice on using the burners

To ensure the burners operate efficiently:

• Use appropriate cookware for each burner (see

table) so that the flames do not extend beyond the

bottom of the cookware.

• Always use cookware with a flat base and a cover.

• When the contents of the pan reach boiling point,

turn the knob to minimum.

Burner ø Cookware Diameter (cm)

Reduced Fast (RR) 22 - 24

Semi Fast (S) 16 - 20

Auxiliary (A) 10 - 14

Triple Crown (TC) 24 - 26

To identify the type of burner, refer to the designs in

the section entitled, "Burner and Nozzle

Specifications".

Start-up and use

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Whirlpool PY 640 T (IX)/HA Mode d'emploi Page 18