Whirlpool WP 89 Mode d'emploi

Naviguer en ligne ou télécharger Mode d'emploi pour Lave-vaisselle Whirlpool WP 89. Whirlpool WP 89 Instruction for Use Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 1
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Whirlpool is a registered trademark of Whirlpool USA
Before using the dishwasher, read the installation and maintenance instructions carefully!
1
GB
5019 396 01224
WP 89
1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example,
according to different loads, extra functions, different settings, water supply temperatures, water hardness and
power supply voltage.
2) Programme for energy data label in conformity with EN 50242. - Information for Test Laboratories:
for detailed
information on the EN/Standard loading comparison test and other tests, contact the following address:
“nk_customer@whirlpool.com”.
1. OVERVIEW
Programme selection button
Press the button (repeatedly) until the indicator lamp
of the desired programme lights up (see table 1.1).
At the end of the wash cycle, the last programme
selected is memorized.
Half Load/Multizone
Half load cycle can be used for the upper or lower
rack. Select the programme then press the “Half load”
button. The indicator lights up, and goes off at the end
of the programme. This function can be used with the
programmes indicated in table 1.1. At the end of the
programme, the most recently selected setting
remains memorised.
Detergent setting upon initial use and when using a
different type of detergent
Indicator lamp off = Powder/gel detergent (factory
setting).
If using combined detergents, press and hold the
button for 3 seconds; the indicator lamp lights up =
rinse aid and salt indicators are deactivated.
From water hardness level 5, the salt indicator remains
active. At the end of the programme, the most
recently selected setting remains memorised.
Delayed Start button
Press the button repeatedly to delay the start of the
programme by 2, 4 or 8 hours. Then press the
Start/Resume button. The remaining time is
indicated by the corresponding indicator lamp. The
wash programme will start after the set time. The
set delay will be memorised at the end of the cycle,
and can be selected by pressing the button again.
Start/Resume button
The indicator lamp lights up during operation, flashes
when the programme is interrupted before completion
and switches off at the end of the programme.
Cancel/Off button
Press the button to switch the dishwasher off or to
interrupt the selected programme.
If the Cancel/Off indicator lamp flashes repeatedly, this
indicates a fault: see chapter 5 “What to do if...”.
Salt level indicator and rinse aid level indicator
These light up at the end of the programme if salt
or rinse aid needs topping up. Only add just before
starting a wash cycle.
Table 1.1.
Overview of programmes
Detergent
dispenser
Consumption
1)
P
Programmes
Available
options
Description of
programme
large small Litres kWh Minutes
1
Sensor 50-65°C
Recommended programme for
routine washes, with dried-on
food (e.g. EN 50242).
X X 7-14 1.00-1.60 70-155 ±
1)
2
Pre-Rinse cold
Crockery to be washed later. 4.0 0.03
14 ±
1)
3
Quickwash 45°C
Lightly soiled crockery, with no
dried-on food.
X 11.0 0.80 30 ±
1)
4
Eco
2)
50°C
Normally soiled crockery.
Energy-saving programme.
X X 11.0 1.05 170 ±
1)
5
Intensive 70°C
Recommended programme for
heavily soiled crockery,
especially suitable for pans and
saucepans.
X X 14.0 1.60 145 ±
1)
Vue de la page 0
1

Résumé du contenu

Page 1 - 1. OVERVIEW

Whirlpool is a registered trademark of Whirlpool USABefore using the dishwasher, read the installation and maintenance instructions carefully!1GB5019

Commentaires sur ces manuels

Pas de commentaire